Installation of Lippert Components Heavy-Duty Replacement Shock LC283280
Question:
LC283280 The bottom nut. Nut closes to the shock. Do U run it down all the way to the shock or cna it go where it is needed.
asked by: Dan
Expert Reply:
Lippert Components Heavy-Duty Replacement Shock # LC283280 has a nut on each end for securing the shock to the mounts on your trailer suspension. These should be tightened against the outside washers enough to secure the shock to the mounts but not so much that you compress the rubber grommets.
It sounds like you might be asking if you could add a second nut inboard of the inside washers to extend the length between the mounting points. Lippert does not recommend this, according to my contact there. The shock is intended to install with the inside washers and grommets right up against the shock tubing on both ends.
If I am not understanding your question correctly please let me know.
Product Page this Question was Asked From
Lippert Heavy-Duty Replacement Shock - Yellow
- Accessories and Parts
- Trailer Suspension Parts
- Shocks
- Lippert
more information >
Continue Researching
- Shop: Replacement Dexter Bolt-On Shock Kit for 2-3/8" or 3" Diameter Axle - Single Axle
- Shop: Lippert Heavy-Duty Replacement Shock - Yellow
- Shop: Roadmaster Comfort Ride Shock Absorbers for Tandem Axle Trailers - 5,200-lb to 7,000-lb Axle
- Video: Lippert Components Trailer Suspension LC283280 Review
- Q&A: Brake Controller Wiring for Ford E-450 Motorhome
- Shop: MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 2-1/4" Long Shackle Straps
- Video: Choosing the Right Trailer Wiring
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Search Results: 44649
- Shop: Trailer Wiring
- Shop: Grease Seals 10-36 (pair)
- Q&A: Wheel and Tire Recommendation For Jet Ski Trailer with Tire Size ST175/80R13
- Search Results: 68149
- Article: How to Choose the Right Trailer Hitch Class
- Video: SumoSprings Trailer Helper Springs Review
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Dexter E-Z Flex Suspension Kit - Double-Eye Springs - Tandem Axle - 6,000 lbs
- Search Results: dust cap
- Shop: Fifth Wheel Hitch
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Search Results: 25580
- Article: How to Accurately Measure Trailer Leaf Springs
- Shop: Brake Controller
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Shop: Shackle Bolt with Locknut for Double-Eye Springs - 3" Long
- Shop: Suspension Enhancement
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Search Results: dust caps