Can Advent Heat Strip be Added to Advent Air Conditioner # ACCOL135

Question

Question:

Can the Advent Air Electric Heat Strip - 5,500 Btu Item # ACMHD be added to this ac?

asked by: Donny W

0

Expert Reply:

Yes, you can use the Heat Strip part # ACMHD with the Advent Air Replacement RV Air Conditioner # ACCOL135 that you referenced. For more info on the heat strip like where and how it installs check out the review link I attached for it.

expert reply by: Jameson C

0

Answer 1

The Advent Air Low Profile RV Air Conditioner System w/ Start Capacitor #ASA96YR comes with everything you need to add a new AC to the bedroom of your RV. If you want to add a heat strip #ACMHD it is available separately.

view full answer...

Answer 2

The Furrion Chill HE RV AC unit part #FR25PR does currently have a start capacitor built into it but it does briefly draw up to 29 amps upon start up. The confusion is most likely related to fact that older version of the Chill did not have a…

view full answer...

Answer 3

For your 28' enclosed trailer I recommend the Furrion Chill HE RV Air Conditioner System - Single Zone - 15,000 Btu - Black #FR23PV. If the ceiling of the trailer isn't too high and you can reach the air distribution box and don't want to…

view full answer...

Answer 4

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 5

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 6

Hi Robert, If you're just wanting to replace the condenser unit on the rooftop and retain use of your current air distribution box and thermostat then you'll just need to determine what style connector your current unit has. If you remove the…

view full answer...

Answer 7

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 8

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 9

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 10

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 11

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 12

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Can Advent Heat Strip be Added to Advent Air Conditioner # ACCOL135

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching