How Can Superchips Flashcal F5 Calibrator be Transferred to Second Vehicle

Question

Question:

before you say can not be re-use for the second car but if i sold the first jeep can i reset and use again for the new jeep.

asked by: Lavoie

0

Expert Reply:

Yes, if you set the vehicle you had the Superchips Flashcal F5 Calibrator # SU3571 installed on back to stock you will be able to then use the calibrator on a second vehicle.

expert reply by: Jameson C

0

Answer 1

No, you cannot use the same Superchips Flashcal F5 Calibrator for Jeep Wrangler #SU3571 on both your 2018 Jeep Wrangler Rubicon and your wife's Wrangler. The Flashcal can only be used with a single vehicle at a time because the original tune is…

view full answer...

Answer 2

Yes, you can change the Superchips Flashpaq F5 tuner to a different vehicle. For example, the Superchips Flashpaq F5 Performance Tuner - Ford - Gas/Diesel, part #SU1845, when programmed, is attached your vehicles VIN. In order to pair it to a…

view full answer...

Answer 3

No there is not. You might be able to contact SuperChips to see if they'll sell you a way to unlock it, but unless you can track down the original vehicle and return it back to stock their programmers cannot then tune a second vehicle. The…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 9

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 10

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 11

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 12

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

How Can Superchips Flashcal F5 Calibrator be Transferred to Second Vehicle

Product Page this Question was Asked From

Continue Researching