Comparing the OEM Subaru Hitch to the Draw-Tite Hitch 76253 on a 2019 Subaru Ascent
Question:
I see that #76263 installs using the same mounting holes as the bumper beam that was removed. The OEM trailer hitch, however, uses frame bracket assemblies installed into the frame hole opening, see page 8 Is there any concern using #76263 since it does not mount into the frame hole opening?
asked by: Shawn
Expert Reply:
The Draw-Tite Max-Frame Trailer Hitch Receiver part # 76253 and the OEM Subaru Trailer Hitch Receiver L101SXC002 actually install using most of the same holes on the vehicle. I looked through the instructions you were referencing to confirm this. The OEM option is a three piece hitch which is why it looks like it installs differently but I can promise you that it replaces the bumper beam just like the Draw-Tite option, it's just rather hard to tell from the instructions.
There will be no concerns using the Draw-Tite Max-Frame Trailer Hitch Receiver on your 2019 Subaru Ascent so long as you abide by the vehicle's listed towing capacity. I have attached an install video for you as well as a photo. There is no drilling required whatsoever.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 750 lbs TW
- 5000 lbs GTW
- 2 Inch Hitch
- Completely Hidden
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: tjsc~24~hd
- Shop: Replacement Manual Crank Handle for Ram Scissor Stabilizer Jacks - 5,000 lbs
- Shop: Scissor Stabilizer Jack - 18-3/4" Travel - 2,500 lbs - Qty 1
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Search Results: trailer jeep style fenders
- Search Results: fender
- Search Results: jeep style fenders
- Search Results: trailer fenders
- Search Results: hp64vr
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector
- Shop: Backing Plate for Tandem Axle Trailer Fender - Steel - 69" x 12"
- Shop: Tekonsha Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger - Top Load
- Shop: 7-Way Molded Trailer Wire Connector, 6' Long
- Search Results: tekonsha trailer wiring
- Video: Choosing the Right Trailer Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Video: Choosing the Right Brake Controller
- Shop: Brake Controller
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It
- Shop: Suspension Enhancement
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
on Trailer Hitch
