Who Makes Replacement Cover for Extang Tuff Tonno Tarp

Question

Question:

Is this replacement manufactured by Extang. The way it is listed I am led to believe it is. When I ordered this part there was no picture available at this time.

asked by: Lee S

1

Helpful Expert Reply:

Yes, the Replacement Cover for Extang Tuff Tonno Tarp part # EX13915 is made by Extang.

expert reply by: Jameson C

1

Answer 1

First you are going to need to identify the cover on your 2013 Toyota Tacoma. Since it was installed by a dealer you will want to first check underneath your tarp for and manufacturer information stamped onto the tarp itself. Next you will want to…

view full answer...

Answer 2

The Extang Tuff Tonno that you have on your 2006 Chevy Colorado would be the part #EX14660. The correct replacement tarp you would need would be the part #EX13660.

view full answer...

Answer 3

The Extang Tuff Tonno Soft Tonneau Cover that fits your 2013 Toyota Tacoma with the 6' bed is part #EX14915 which makes the replacement cover part #EX13915. The part #EX13710 that you referenced is a replacement for the Extang Tuff Tonno that…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Who Makes Replacement Cover for Extang Tuff Tonno Tarp

Product Page this Question was Asked From

Continue Researching