Can Hitch Extender be Used with Swagman Escapee # S694FR

Question

Question:

Is there a recommended hitch extension to increase the distance so the handle bar is not resting against/striking the rear window?

asked by: Michael O

0

Expert Reply:

We have hitch extenders like the # HE06 which will extend the hitch out an additional 6 inches and can be used with bike racks like the Swagman E-Spec part # S94FR that you referenced but you should note that when you use an extender like this you cut the capacity of the hitch by 50 percent.

expert reply by: Jameson C

0

Answer 1

Using the hitch extension will reduce the tongue weight capacity of the trailer by 50 percent. But if you have a 2 1/2 inch trailer hitch receiver and use the Titan hitch extension #RP45292 the tongue weight capacity will not be reduced. At the 24…

view full answer...

Answer 2

It sounds like you already have a 2" receiver, so the reason for wanting the Reese Hitch Box Extension, part #RP45292 is for the extension. Rather than trying to use an adapter to expand your 2" receiver to 2-1/2" (which we do not…

view full answer...

Answer 3

Yes, the Swagman Bike Cover for RVs part #S24FR is larger than the previous model. This cover measures approximately 67" tall x 84" wide (bottom) x 58" wide (top). It should work to cover most platform type bike racks with bikes.

view full answer...

Answer 4

Yes. The Swagman Bike Cover for RVs - Large - 2 Bikes #S24FR is designed to work with both platform and hanging style bike racks, so it will work well with your Swagman Escapee rack.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

I recommend the Roadmaster Dual Hitch Receiver Adapter, 10" Drop/Rise item #RM-077-10. This adapter was designed for this type of set up. Your Jeep Rubicon and Swagman E bike rack weigh well below the 10,000 lbs maximum capacity of this hitch. I…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

Yes, you can install a Curt Trailer Hitch Receiver #C11433 on your 2019 Chevrolet Spark. This receiver is capable of supporting up to 200lbs of tongue weight. With each of the Lectric 3.0 e-bikes weighing roughly 60lbs without the battery you will…

view full answer...

Answer 11

As long as the flat tow wiring is wired in before the 4-Way #C93ZV and you connect the power for the converter directly to the battery it will work. I have seen several use Magnetic Lights #TL21RK which they will wire in on the main harness to have…

view full answer...

Answer 12

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Can Hitch Extender be Used with Swagman Escapee # S694FR

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching