Cut Out Dimensions Needed For Installing RearView Safety Flush Mount Bracket # RVS-421

Question

Question:

There is a photo here which shows the dimensions are Overall its 7.875 inches wide and 6.125 inches tall. That appears to be the overall edge to edge dimension, what is the dimension of the box which would recess into the dash leaving the lip to cover the rough opening? Thanks.

asked by: William H

0

Expert Reply:

The cut out dimensions needed to install the RearView Safety Flush Mount Bracket # RVS-421 are 7-1/4 inches wide by 5 inches tall.

expert reply by: Jameson C

0

click to enlarge

Jim H.

5/31/2020

Can this be used with the Furrion Vision S 7 Inch monitor?

Reply

Chris R.

6/4/2020

The Flush Mount Bracket # RVS-421 mentioned above is designed specifically for the Rear View brand monitors and won't work for the Vision S unit. Unfortunately there isn't a comparable bracket for the Vision S systems.

Reply

Answer 1

The Rear View Safety Color Monitor #RVS-6139Q will be able to support up to 4 cameras including the Rear View Safety Forward Facing Camera #RVS-776-FF-5P you mention, and comes with a mounting plate. To wire the monitor and the cameras, use the…

view full answer...

Answer 2

Based on the information I could find it appears the Zone Defense monitor on your 2011 Monaco Diplomat RV motorhome connects to 4-pin cameras. This would require the Buyers Products RV Backup Camera System #3378883010 as the Rear View Safety System…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

view full answer...

Answer 7

The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do end up…

view full answer...

Answer 8

I have a complete replacement camera system option for you, but since your current camera system is no longer made there are no replacement cameras available that use your same monitor. I recommend replacing it with the Voyager WiSight 2.0 Wireless…

view full answer...

Cut Out Dimensions Needed For Installing RearView Safety Flush Mount Bracket # RVS-421

Product Page this Question was Asked From

Continue Researching