Replacement Bearings and Seal Recommendation for Kodiak Disc Brake Rotor/Hub on Keystone Montana

Question

Question:

2013 3100rl keystone montana i got the kodiak disc brake system i want to replace the bearing seal and race which should i get

asked by: Rafael R

0

Expert Reply:

If you have the Kodiak disc brake rotor/hub part # KHR1389D that you referenced the bearings you need are part # 25580 and # 02475 and then the grease seal is the part # RG06-070. If your trailer has 7k axles installed on it these part numbers would be what you'd need.

expert reply by: Jameson C

0

Answer 1

As far as the labeling of the Kodiak Disc Brake Kit - 13" Rotor - 8 on 6-1/2 - E-Coat - 9/16" Bolts - 8K Dexter Disc Kit #K2R89DDE, Dexter is the parent company of Kodiak. The reason this particular kit calls out Dexter is anything above 7k…

view full answer...

Answer 2

Are you backing your trailer into the water when the hubs are hot? Typically that's what causes water intrusion into trailer hubs that use oil seals. If the seal can keep oil in without leaks it would be waterproof so the hot hub theory is…

view full answer...

Answer 3

There are differences in them but we do have what you are looking for and they can in some situations be used together. The Replacement Trailer Hub Bearing you have part #02475 and Replacement Race for 02475 Bearing part #02420 are designed to work…

view full answer...

Answer 4

The "KTC 7600" stamped on the brake pad doesn't look to be a part number, so I can't cross reference it, but we do know you have Kodiak ceramic brake pads. So to determine the correct brake pads, all you need to do is match up…

view full answer...

Answer 5

I took a look at the online owner's manual for your 2017 Honda Fit EX. It starts off by stating that only the manual transmission models of the Honda Fit can be towed behind a motorhome with all four wheels on the ground. For extended towing…

view full answer...

Answer 6

The grease cap part number that you referenced cross references to a drive in cap with a 2.44 inch outside diameter. If you have a standard cap then the Grease Cap, 2.44 inch OD Drive In, item #RG04-060, is the correct part. If you have a grease…

view full answer...

Answer 7

The standard torque on a Redline Trailer Wheel Lug Nut - 9/16 inch, part #6-53, is 135 to 145 ft lbs. This is the torque range that is normally used. If the instructions for the wheel are saying 110 ft lbs there might be a reason, like the wheel…

view full answer...

Replacement Bearings and Seal Recommendation for Kodiak Disc Brake Rotor/Hub on Keystone Montana

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching