Rear Observation Camera for Pre-Wired 2019 Jayco White Hawk
Question:
I have a Jayco 2019 White Hawk that is prewired for a Furrion camera. I am considering a Furrion 4.3 system. Will this act as a full time observation system as well as a back up system, right out of the box and connected to the pre wired area of my new trailer or do I have to make any modifications or adjustments for it to function both ways.
asked by: Ronald E
Helpful Expert Reply:
I reached out to my contact at Jayco regarding your 2019 White Hawk and she said that it actually depends on the specific submodel and any options that may have been added at the factory as to whether the pre-wired setup is connected to a constant power source for observation or the reverse signal for a backup camera. If you are able to give me your VIN I will be happy to reach out to her again and she should be able to provide me with the specific setup on your RV with that number.
Otherwise you can simply use a circuit tester to test the wiring behind the existing bracket on your White Hawk to see if it gets power only when the RV is shifted into reverse. If this is the case you can certainly change it by simply connecting the wiring to a constant 12V source like the running lights signal instead. This would allow the camera to be on both during normal driving and backup scenarios.
Either way for your pre-wired Jayco White Hawk the Furrion RV Observation System # FOS43TASF that you referenced will work perfectly. This will be an easy plug-and-play installation and it features a waterproof camera with infrared LEDs for nighttime vision. I have attached a short video review that you can also check out.
Product Page this Question was Asked From
Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen
- RV Camera System
- Backup Camera
- Observation Camera
- Built-In Microphone
- Touch Screen
- Anti-Glare
- Mirrored Image
- Night Vision
- Motion Detecting
- Waterproof
- Wireless Signal
- 120 Degrees
- Dashboard Mounting Bracket
- Suction Cup Mount
- Below Rear Clearance
- 4.3 Inch Display
- 1 Camera
- Furrion
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Suspension Enhancement
- Shop: Brophy Ball Mount - 1" Rise, 2" Drop - 9-3/4" Long - Aluminum - 8,000 lbs
- Shop: Timbren Rear Suspension Enhancement System
- Shop: Firestone Coil-Rite Air Helper Springs - Rear Axle
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: light wiring harness
- Shop: Ball Mount 3/4" Rise or 2" Drop - 12-5/8" Long
- Shop: Brophy Ball Mount for 2" Hitch - 3/4" Rise, 2" Drop - 13-1/4" Long - 10,000 lbs
- Shop: Curt RockerBall Shock Absorbing 2" Hitch Ball - 1" Diameter Shank - Chrome - 7.5K
- Shop: Brake Controller
- Shop: Redarc Tow-Pro Elite Brake Controller - Dash Knob - 2 Braking Modes - 1 to 3 Axles - Proportional
- Video: Review of Ultra-Fab Products RV and Camper Hitch - RV Bumper Mount Hitch - UF35-946402
- Video: Ultra-Fab 2 inch Motor Home Trailer Hitch Review
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Video: Timbren Rear Suspension Enhancement System Test Course TTORSEQ1
- Q&A: Air Helper Springs for 2008 Toyota Sequoia Limited
- Video: Curt Ball Mounts - Fixed Ball Mount - C45342 Review
- Q&A: How to Match Different Heights of Hitch Ball and Trailer Coupler for Safe Level Towing
- Q&A: Hitch Ball Recommendation for a 2019 Jayco Jay Flight SLX 8 264BH
- Video: Air Lift AirLift 1000 Air Helper Springs Review
- Search Results: cigarette lighter extension
- Search Results: cigarette lighter outlet
- Search Results: cigarette lighter adapter
- Search Results: 12 volt power socket
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Q&A: Camera Kit for RV that has Furrion Bracket Mounted on Rear # FRCBRKT-BL
- Article: Trailer Maintenance Schedule
- Q&A: Location of Heating Element on Atwood GC6AA-10E Water Heater
- Q&A: Troubleshooting 6 Gallon Atwood Water Heater Not Working on Electric But Works on LP