Does the Winch Remote Control Module Need to Be Mounted on Top of the Motor or Can Extension Work?

Question

Question:

Can the remote control module be moved using 4ft battery terminal cables away from the winch motor and still operate the winch? Thank you

asked by: Jon H

1

Helpful Expert Reply:

The Bulldog Winch Trailer Winch - Wire Rope - Roller Fairlead - 4,400 lbs # BDW15019 will allow you to use a thick enough gauge wire like you would find with battery cables to move the inch remote 4 feet away from the winch and still utilize the 20 foot lead and rocker switch on the remote control. If you want to use a wireless remote part # BDW20212 is available separately and would remove the need to change the transmitter control position.

You can use the Bulldog Winch Front Wiring Kit - Quick Connect to Terminal End - 3 Gauge - 7-1/2' Long # BDW20025 to make your connectors.

expert reply by: Jason S

1

click to enlarge

Answer 1

While we do have a U.S.A. made option, the Bulldog Winch #BDW15018 is made in China. For a great American alternative, the highest capacity U.S.A. made winch we have is the Dutton-Lainson StrongArm Electric Winch w/ Pulley Block, AC Powered…

view full answer...

Answer 2

The main two differences between the Bulldog Winch Trailer Winch part #BDW15020 and part #BDW15018 are rope diameter and motor power which results in different weight capacities. They both have the synthetic rope, wired remote, and hawse fairlead.

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 5

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 6

The amount of bow that's put into trailer axles like the #7359765 is based on about how much a trailer is typically going to weigh that has a 3,500 lb capacity. So there's a bit of approximation and obviously it can't be totally perfect…

view full answer...

Answer 7

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Does the Winch Remote Control Module Need to Be Mounted on Top of the Motor or Can Extension Work?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching