bing tracking image
Q & A Icon

Troubleshooting King Pin Not Releasing From B&W Companion 5th Wheel Hitch  

Question:

I tried to set up my trialer end the hitch will not release the from the hich

0

Expert Reply:

The most common cause for the jaws of a 5th wheel hitch like the B&W Companion # BWRVK3400 not to open is too much tongue weight still on the truck. You will want to make sure that your trailer's landing gear is adjusted properly so that the trailer is level and the pressure/weight is relieved from the hitch and your truck.

It's also possible that you are simply parked on unlevel ground, which can lead to the jaws remaining wrapped around the king pin even after turning the handle. When this is the case you should still be able to pull the truck away (as long as the landing gear is properly adjusted as mentioned above) and the king pin will open the jaws as you continue to pull away.

If this does not resolve the issue please let me know and I will be happy to look into this further.

expert reply by:
0
Chris R

Ben

8/2/2020

I can't remove the ball from the bed of the truck. Pin release moves in and out from the wheel well, ball goes up and down, can't remove.

Etrailer Expert

Chris R.

8/12/2020

If the locking pin is released and the ball won't come out, there's likely a good deal of corrosion binding it in place. The best advice I can give is to apply a healthy dose of spray lubricant like WD-40 and try to hammer up from the bottom and knock it back and forth as well. It will eventually loosen up but you may need to repeat this process a few times.

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>