Can Redline Ramp Spring # RS16933RH Be Used On 1-1/4 Inch Shaft

Question

Question:

Can I usde this springs on a 1.25 shaft?

asked by: Dan C

1

Helpful Expert Reply:

The Ramp Spring # RS16933RH that you referenced can indeed be used with a 1-1/4 inch shaft without a problem. We have verified this with Redline.

I have attached a short video demonstration on this spring that you can also check out.

expert reply by: Chris R

1

Answer 1

Heavy duty ramp springs #RS16933RH and #RS16933LH install on the hinge of the ramp. I have included a picture of what this looks like for you. Not all trailers are exactly the same but this should give you a general idea of how the springs install.

view full answer...

Answer 2

I do have an option for you but the Stromberg Carlson 4000 Series 5th Wheel Louvered Tailgate part #VGD-10-4000 does not have a spot for the factory backup camera. Therefore you would either need to find a way to mount this yourself, go without, or…

view full answer...

Answer 3

For the Edge CS2 Evolution Diesel Tuner you will need to enter the programming menu. You will turn on your vehicle without starting it. Then use the Menu button to open the main menu and scroll down with the arrow to the Programming on the screen.…

view full answer...

Answer 4

When selecting ramp springs for a trailer ramp, you will want to know the diameter of your hinge pin and how much space you have available in the hinge. A typical horse trailer or utility trailer ramp uses 3/4 inch hinge pins and would require two…

view full answer...

Answer 5

I reached out to Demco to get the bolt hole spacing on the Demco Channel Tongue Trailer Coupler #DM13203-52. The bolt holes measure 3/4 in from the top of of the coupler to the center of the hole. This is the same measurement for the distance from…

view full answer...

Answer 6

My online research did not turn up any direct replacement parts for the HB732 hub you referenced. However, we can help you select new replacement hubs. The things you need to know in order to select replacement hubs are: the bolt pattern on your…

view full answer...

Answer 7

You are correct that the 2K rating of the Ramp Spring #RS16933LH is for when it has a load on it. I spoke with my contact at Redline about your question and they confirmed this. The inch/pound rating that you mentioned is what I found as well.

view full answer...

Answer 8

The 2K Torque Ramp Spring #RS16933RH is an industrial strength spring. It is designed for up to 90 degrees of deflection, but most people by hand can cause no deflection at all. It is designed to be used with the LH #RS16933LH, and is for heavy ramps…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Can Redline Ramp Spring # RS16933RH Be Used On 1-1/4 Inch Shaft

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching