Best Storage Cover for a 25 Foot Long Gooseneck Horse Trailer

Question

Question:

my horse trailer if I measured right is about 25 feet. should I go with the up to 247 or the cover that is 247 to 287?

asked by: Heidi

0

Expert Reply:

If your gooseneck horse trailer measures 25' long from the tip of each end then I recommend using the Adco SFS AquaShed Cover for Gooseneck Horse Trailer part # 290-46012 which is rated for trailers up to 28' 6" long. It will also accommodate trailers up to 86" wide and 94" high. The cover comes with a storage bag and a two year warranty. It is gray in color.

expert reply by: Conner L

0

click to enlarge

Answer 1

Yes, this will work. The AMPLock Trailer Coupler Lock for Atwood Gooseneck and Flat Nose Couplers #AMP49FR is for Atwood Goosenecks, which it looks like you have. Using the pictures you provided it looks similar to the Atwood gooseneck coupler that…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…

view full answer...

Answer 6

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

view full answer...

Answer 7

The Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box #GY38FR is not going to allow for any additional turning clearance than the 5th wheel king pin with a fixed point hitch. We have offset gooseneck ball options depending on what type of…

view full answer...

Answer 8

Hey Susan, so we don't have any locks designed to lock a gooseneck coupler's inner tube to the outer tube that is welded to the trailer chassis so the best option we have would be a wheel lock like the part #288-02020 which will prevent the…

view full answer...

Best Storage Cover for a 25 Foot Long Gooseneck Horse Trailer

Product Page this Question was Asked From

Continue Researching