Are Cable Handles of Valterra Waste Valve Bodies w/ Flexible Cables Labelled

Question

Question:

Are the handles marked Black and Grey?

asked by: Roger

0

Expert Reply:

The handles of the Valterra Waste Valve Bodies w/ Flexible Cables for RV Black Water and Gray Water Tanks # TC1372 only say "Valterra" they are not labelled with what they control.

expert reply by: Jameson C

0

Answer 1

The flanges typically have a gasket between them and the gate valve with a groove in the valve holding them in place. Putting two flanges together with just the gaskets touching each other instead of having an actual groove in the plastic to sit…

view full answer...

Answer 2

I may have a solution for you, but these are a universal part and not going to be trailer specific, so you will need to measure the length of the wheel well and choose the one that most closely matches your coach. You could use the Phoenix USA…

view full answer...

Answer 3

According to Valterrra, if your #TC1372 waste valves are fully closing, but are still leaking you'll want to replace the seals. You'll need both the 3 inch seal kit, part #T1003-9VP and the 1-1/2 inch seal kit, part #T1001-9VP

view full answer...

Answer 4

There is a screw nut adjustment at the lever end that can be adjusted, This could have been turned inadvertently over a period of time lengthening the cable. Turning back out should lengthen the distance of the shield making it close tight.

view full answer...

Answer 5

The valves you are seeking to replace are made by many different manufacturers and are a standard size. The function of the valve is what you want to pay attention to as there are T-handle and cable options and then of course black water versus…

view full answer...

Answer 6

The Valterra Waste Valve Bodies w/ Flexible Cables for RV Black Water and Gray Water Tanks - 72" Item #TC1372 is a correct replacement for your gray and black tank valves. I have attached a picture from the guide to help with placement of…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 8

Hi Mark; thanks for the question and I have some good news for you as we have the exact 5th wheel to gooseneck adapter to replace the Turning Point pin box on your Jayco Eagle HT 30.5 CKTS. The correct part is the following: - Gen-Y Hitch Shock…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Are Cable Handles of Valterra Waste Valve Bodies w/ Flexible Cables Labelled

Product Page this Question was Asked From

Continue Researching