Replacement Tarp Recommendation for 2014 Chevy Silverado 1500 6 1/2 ft bed With Extang Trifecta

Question

Question:

I have a 2014 Silverado with the 6 ft 6 inches bed. What model tonneau cover do I need for a replacement? The cover I have that’s ripped is a Trifecta 2.0 by extang. Thank you!

asked by: Matt

0

Expert Reply:

The replacement tarp you are in need of is the part # EX94450-20 since the Extang Trifecta 2.0 you have on your 2014 Chevy Silverado 1500 6-1/2 foot bed is the part # EX94450. This only fits the 2.0 versions of the Trifecta.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Good morning Michael I can definitely point you in the right direction. There are a few different Extang covers that fit the 2018 GMC Sierra 1500 with the 6.5' bed. Generally, we like to get a model number or serial number from the cover which we…

view full answer...

Answer 2

It will be difficult to match up a replacement tarp for the Extang Trifecta tonneau cover on your 2015 Silverado 1500 6-1/4' bed without a serial number. If you have Extang Trifecta Signature 2.0 Soft Tonneau Cover - Folding CANVAS #EX94450 then…

view full answer...

Answer 3

If you have the Extang Trifecta 2.0 Soft Tonneau Cover part #EX92450 which is a fit for a 2017 Chevrolet Silverado 1500 with 6-1/2' bed then you need the Replacement Tarp for Extang Trifecta 2.0 Soft Tonneau Cover part #EX93450-20. If you have…

view full answer...

Answer 4

I believe you meant to say you have an Extang Trifecta on the 2017 Chevy Silverado 1500 6-1/2 foot bed. It sounds like you have the Extang Trifecta Signature 2.0 Soft Tonneau Cover part #EX94450 and you were missing a digit from the question. The…

view full answer...

Answer 5

What year is your truck? The tarp you referenced is a replacement for a short bed Dodge Ram between 2002 and 2008.

view full answer...

Answer 6

I am happy to determine the replacement cover for you but I would need the serial number off of your older Extang cover. The easiest way is to locate the serial number. Most of the time the serial number can be found on the driver's side front…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Hey Dustin, thanks for reaching out! I will recommend SumoSprings over Timbrens all day everyday because they are much more forgiving when the vehicle is unloaded. We've actually joked around here about how the Timbren kits will either give you…

view full answer...

Answer 12

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...