Will Brake Controller Control Three Axles of Trailer Brakes

Question

Question:

does electric brakes work off 12volt brake control three axle braking it should work all three axles

asked by: Glen

0

Expert Reply:

If your trailer has three axles that all have electric trailer brakes then yes, a brake controller will be able to activate them all at the same time.

expert reply by: Jameson C

0

Answer 1

There's really no set hard and fast rule on the interval of time at which trailer brake assemblies should be replaced, but once the friction material on the brake pads gets down to about 1/16 of an inch or the magnet gets grooved or worn to the…

view full answer...

Answer 2

I would be happy to recommend the correct replacement electric trailer brakes for you, but the 3175030707 did not cross reference to any brake assemblies. To determine the correct brake assemblies I would need to know the weight rating of your axle…

view full answer...

Answer 3

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 4

In regards to trailer hubs, the maximum temperature is 200 degrees Fahrenheit. The average can vary but I'd say around 100 to 120 degrees Fahrenheit is normal. If you are experiencing abnormal temperature then the spindle nut is either too tight…

view full answer...

Answer 5

To wire your electric brakes you will want to run 10 gauge wire #10-1-1 to one of the brakes and run it to the other brake, using butt connectors like #05732-2 to connect them. The grounds will not be spliced, each brake assembly should have its own…

view full answer...

Answer 6

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 7

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 12

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...