Replacement Hasp for Polar Cam-Action Latch Kit

Question

Question:

Is this for the cable kit for a toyyhauler?

asked by: David M

0

Expert Reply:

Replacement Hasp # PLR258-101 can be used as a stand alone item but it is a replacement for the hasp that comes with Cam-Action Lockable Door Latch Kit # PLR258-002. It does not sound like what you are looking for though. To determine if we have what you are looking for I would need to see it. If you can please email me a picture.

expert reply by: Michael H

0

Answer 1

If your breakaway battery is dead, your brakes should operate while connected to your vehicle's 7-way trailer connector. If your brakes are not operating, then it sounds like you might have a short in the brake wiring of the trailer. Battery…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 4

Yes, the Dexter E-Z Flex Equalizer #K71-655-00 will indeed work with the standard 1-3/4" wide double eye leaf springs.

view full answer...

Answer 5

We do offer a few of the 7-3/4" long equalizers with 3 9/16" holes. Unfortunately, the standard equalizers in this size like the #TREQE1 are not greaseable. There is the Dexter E-Z Flex Equalizer #K71-655-00 which is a 7-3/4" long…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Hey Scott you will need to get the width of your ramp as well as the weight of the ramp to pick out what you'd need. For example the part #M394FR is for 8 foot wide ramps and has a weight capacity of 185 lb. I attached a link to all of the…

view full answer...

Answer 8

Yes, the Kenda Karrier ST175/80R13 Radial Trailer Tire #AM31990 will indeed fit on the etrailer Hitch Mounted Spare Tire Carrier #e98ZR. The spare tire carrier will work with virtually any 4 lug, 5 lug or 6 lug wheel. The #AM31990 wheel uses the…

view full answer...

Answer 9

Hey Lou, so the install of the Conventional Ramp Door Spring part #362SA7218 is something that should be done by someone who has experience winding garage springs. The amount of turns or preload will be the amount that gives you the correct amount of…

view full answer...

Answer 10

To test the weight of your ramp door, you will want to get the door all the way down to the ground and then on a scale of some kind (a bathroom scale can be used for this if it's the only thing available). This will be when the door is at its…

view full answer...

Answer 11

To determine the correct weight springs you will need a scale to determine how much weight is on the door when it lays out on the ground. You will place the scale on the ground in the center of the landing path of the door edge. This will tell you…

view full answer...

Replacement Hasp for Polar Cam-Action Latch Kit

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching