Need Trailer Adapter To Connect 4-Way Trailer Connector To 7-Way on 2011 Honda Pilot

Question

Question:

Trying to find an adapter for the plug in my 2011 Honda pilot to fit a 4 way pin on my trailer?

asked by: Ken C

0

Expert Reply:

If your 2011 Honda Pilot has a 7-way trailer connector, the item you selected, Hopkins 7-Way RV to 4-Way, part # HM47365, will work for you.

The # HM47365 connector will allow you to connect the 4-way connector on your trailer to the 7-way connector on your Honda Pilot.

expert reply by: Reno H

0

Answer 1

Since you had a trailer brake controller hardwired to your 2021 Honda Odyssey and a 7-way connector installed you can use the 7-Way RV to 4-Way Flat Trailer Connector Adapter #HM47365 which will plug into your 7-way connector and give you a 4-way…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

There are a few different reasons why turning your running lights on keeps your brake lights from working. The first is a bad ground. Check all of the ground connections for your lights and make sure that they are securely connected to a clean,…

view full answer...

Answer 4

What we have found is that when installing a wiring harness such as the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118778 in a 2019 Honda Ridgeline, that 12-pin plug you are referring to can be frustratingly difficult to find…

view full answer...

Answer 5

The connector pictured is not the correct one for the black module of the Tekonsha T-One Wiring Harness #118778 to install into. The correct one will be located behind the access door in the driver side of the rear cargo area in your 2019 Honda…

view full answer...

Answer 6

This can be a bit tricky but it sounds like you might be looking in the wrong spot on your 2019 Honda Ridgeline to install the T-One Vehicle Wiring Harness #118778. The directions don't do a great job of making this more transparent but the…

view full answer...

Answer 7

It's very easy to install a trailer brake controller on a 2021 Honda Ridgeline. I recommend the Tekonsha Prodigy P3 Trailer Brake Controller part #90195 which comes with a harness that you could simply attach to the one that came with the…

view full answer...

Answer 8

In regards to the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part #118778 which is a fit for a 2020 Honda Ridgeline, there will be two connections one inside the vehicle and one outside. These locations will both be listed in the…

view full answer...

Answer 9

Thank you for the photo, it was helpful. From that it simply looks like you need to remove the locking tab of the tow plug on your 2018 Honda Ridgeline. The fastener at the top needs to be removed (what the arrow is pointing at) by sliding it…

view full answer...

Answer 10

I called Tekonsha and they said they have had one other customer with this issue while using the T-One Vehicle Wiring Harness part #118778 on a 2019 Honda Ridgeline. The cause of this issue was a bad converter box so that may be what is causing your…

view full answer...

Answer 11

I attached a picture that shows what both connectors on your 2019 Honda Ridgeline look like for installing the Tekonsha wiring kit part #118778 that you referenced. The picture with the letter A on it is the 12 pin connector located near the back…

view full answer...

Answer 12

In order to remove the cap to install the #118778 you need to remove the dark blue fastener from the housing by sliding it rearward. Unfortunately I do not have a picture of the locking tabs but they are on the side of the connector. Pressing down on…

view full answer...

Need Trailer Adapter To Connect 4-Way Trailer Connector To 7-Way on 2011 Honda Pilot

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching