Front Hitch Recommendation for 2015 Jeep Wrangler Rubicon Unlimited

Question

Question:

Looking for a front 2inch receiver, for a 2015 Rubicon Unlimited pictured below

asked by: Norris W

0

Expert Reply:

Thanks for the picture of the front end of your 2015 Jeep Wrangler Unlimited, based on that we know that the Draw Tite front hitch part # 65069 is a confirmed fit and will work well.

I attached an install video for this hitch for you to check out as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

After comparing the two front hitches we have available for the 2016 Jeep Wrangler Unlimited, I agree with you and recommend the Draw-Tite Front Mount Trailer Hitch Receiver #65069 over the Curt Front Mount Trailer Hitch Receiver #31432. The…

view full answer...

Answer 2

Essentially there is no difference between the two part numbers you referenced. The #65069 is a newer part number that Draw Tite released that happens to have a better price point. And #65055 is no longer available. The #65069 will work well on your…

view full answer...

Answer 3

From my research I found the FHK31432 plow you mentioned requires a front hitch with a 2 inch receiver opening and a minimum tongue capacity of 300 lbs and minimum tow capacity of 3,000 lbs. We have just what you are looking for. The trim package on…

view full answer...

Answer 4

Here's what Draw Tite says about the booster pump and the install of their Draw Tite hitch part #65069 on a 2017 Jeep Wrangler Unlimited. 2012 AND UP MODELS MAY REQUIRE TEMPORARILY MOVING THE BRAKE BOOSTER PUMP, REMOVE THE FORWARD MOST BOLT FROM…

view full answer...

Answer 5

The front mount hitch receiver #65069 was designed later and therefore can back fit older models of the Wrangler. So it fits Wranglers from 2007 to 2017. However, since the discontinued hitch #65055 had already been designed it only fits up through…

view full answer...

Answer 6

There are both factory and aftermarket backup camera systems available for the 2016 Jeep Wrangler Unlimited and with many of these the presence of a spare-tire-mount bike carrier like the Yakima SpareRide #Y02599 will at least partially block the…

view full answer...

Answer 7

Older versions of the Draw Tite front hitch part #65069 had a second hole in the hitch tube which allowed it to be used with a now discontinued anti-rattle J-hook system that they offered, but since they no longer make that they stopped putting the…

view full answer...

Answer 8

Sometimes hitches get bent in shipping so what you can do is use some leverage to bend the hitch back out to the correct dimension needed. As long as when you bend it back no paint flakes or metal creases you are totally fine.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Front Hitch Recommendation for 2015 Jeep Wrangler Rubicon Unlimited

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching