Front Mount Trailer Hitch Installation - 2015 Jeep Wrangler Unlimited - Curt Video

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

According to my research and what I read in an online copy of the owner's manual for your 2016 Jeep Wrangler Unlimited, your vehicle is capable of being flat towed without major modification. There are specific steps that must be followed…

The Curt Front Mount Trailer Hitch #31432 is designed to work with a 2009 Jeep Wrangler Unlimited with a standard factory bumper. If you do not have the factory standard bumper there is no guarantee it will work. I have attached a drawing that…

The front hitch part #31432 has been confirmed as a fit for your 2015 Jeep Wrangler and has a 350 lb vertical weight capacity. As long as the weight of the upright bar and people in the hammock weigh less than that you should be fine.

I attached a picture of the Curt Front Hitch part #C31028 installed on a similar Jeep Wrangler as your 1997 model. I also attached a set of installation instructions for you to check out that are very detailed. The hitch mounts through holes on the…

I went out to our warehouse for you and measured the Draw-Tite Front Mount Trailer Hitch Receiver part #65048. The actual cross tube is 28-1/4" long. The bolt holes are 31" apart on center and the outside to outside flange…

I attached a picture that has the most relevant dimensions of the Curt #31408. The length of the main crosstube as well as the distance between the mounting holes. The vertical height would be just a little over 2-1/2 inches. Our hitch…

We've got what you're looking for. The Curt Front Mount Hitch Receiver, part #C31028 mounts to the undersides of the frame members at the front of your Jeep so that the receiver opening is located under the front bumper, as you can…

Both the Curt #31408 and Draw-Tite #65048 mount to the top of the bumper as you referenced. I believe you are correct that the hitch mounted snow plow won't work with these, because both SnowBear and Detail K2 snow plows we carry all use…

When wiring a 7-Way on your trailer with 5 wires, your green wire will be right turn/brake, the yellow wire will be left turn/brake, the brown wire will be the taillights, and the white wire will be the ground. You will want to find out if the blue…

To determine why you do not have any power on the blue brake output wire, I recommend starting at your brake controller. First, make sure the brake controller is on and receiving power. Most brake controllers have 4 wires, blue (brake output to…

To flat tow your Jeep Wrangler JK behind your motorhome, you will need a base plate kit, tow bar, safety cables, tail light wiring harness, and a supplemental braking system. Depending on the year of your Wrangler, you may also need a Brake-Lite…