Troubleshooting Front Hitch that is 1/2 inch From Fitting Frame Dimension
Question:
I bought one of your front end hitches for a 2009 jeep wrangler. The hitch measures 26 1/4 inches wide, my frame measures 26 3/4 do I need to ues spacers to fill that 1/2 or is it the wrong one?
asked by: Kevin W
0
Expert Reply:
Sometimes hitches get bent in shipping so what you can do is use some leverage to bend the hitch back out to the correct dimension needed. As long as when you bend it back no paint flakes or metal creases you are totally fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: My Trailer Hitch Doesn't Fit
- Q&A: 2015 Jeep Wrangler Front Hitch Recommendation
- Q&A: Install and Removal of Both the Draw-Tite and Curt Front Hitch on a 2016 Jeep Wrangler Unlimited
- Q&A: Differences Between The Front Hitches part # 65055 and # 65069 for a 2015 Jeep Wrangler
- Q&A: Does Vacuum Pump of 2017 Jeep Wrangler Unlimited Need to be Moved to Install Front Hitch
- Q&A: Front Hitch Recommendation for 2015 Jeep Wrangler Rubicon Unlimited
- Q&A: Does Draw Tite Front Hitch 65069 Have One or Two Pin Holes
- Q&A: Front Mount Trailer Hitch Receiver to Fit 2017 Jeep Wrangler
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Which Hitches are Made in the USA
- Article: Towing a Trailer with a Jeep Wrangler - Copy
- Article: What is Boondocking