Can CURT Font Mount Trailer Hitch C31013 Be Mounted on a 2001 Toyota Tacoma with a Grille Guard
Question:
Can a front hitch be mounted with a full grille guard on a 2001 Toyota Tacoma? I know I have seen this done on other trucks but after reading the installation instructions for both I am beginning to question whether it is possible on mine.
asked by: Chad
Expert Reply:
You have done the right thing by reading the installation instructions. Since CURT Front Mount Receiver, # C31013, was not tested on vehicles with any type of grille guard, the only way to determine fit is to look at the instructions for both parts.
In the CURT instructions which I have linked for reference, you will see that at the front frame rails of your 2001 Toyota Tacoma there should be 3 holes. The front most hole is just a hole that will be enlarged to install the hitch. The 2 holes behind that have weldnuts inside. If the grille guard you have mounts in the same place of needs that area of the frame for any reason, the hitch cannot be mounted.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 350 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How Much Ground Clearance Will Be Lost With C31013 Installed On Vehicle
- Shop: Trailer Hitch
- Q&A: Dimensions of Curt Front Hitch C31013
- Shop: Front Mount Hitch
- Q&A: Bolt Hole Spacing of the Curt Front Mount Trailer Hitch Receiver Part # 31026
- Shop: Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Q&A: Dimensions for the Curt Hitch part # 31198
- Q&A: Front Trailer Hitch Receiver For Transporting a Dirt Bike With a 2004 Toyota Tacoma
- Q&A: Front Mount Trailer hitch for a 2002 Toyota Tacoma 4x4 Double Cab
- Q&A: Draw Tite Hitch that Fits 2001 4Runner SR5 4WD
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Bulldog Winch Quick-Connect Set w/Dust Cover - 175 A - 2 ga
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Video: Curt Hitch Fabrication Parts - Receiver Tube - E17 Review
- Shop: Nerf Bars - Running Boards
- Search Results: hitch receiver tube
- Shop: Roof Rack
- Shop: Vehicle Snow Plows
- Search Results: bumper mount hitch
- Search Results: trailer hitch
- Article: How to Choose the Right Trailer Hitch Class
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Search Results: hitch
- Article: My Trailer Hitch Doesn't Fit