Will the Brophy Camper Tie-Downs Part # HSBP Fit a 2015 Chevrolet Silverado 3500

Question

Question:

2015 Silverado 3500 single rear wheel 8foot bed and Sunlight cabover popup camper. Are these compatible with the Brophy mounts? Thanks

asked by: Robert

1

Helpful Expert Reply:

The Brophy Clamp On Camper Tie-Downs part # HSBP will fit your 2015 Chevrolet Silverado 3500. However, we have not yet tested them on this truck while using a Sun Lite Truck Camper so I would not be able to confirm fitment though I do not see any reasons as to why they would not work for you.

I have attached a dimensional photo of the tie downs for you as well so you can get a better idea of how they would work for you. I have also attached a list of our frame mounted camper tie downs which are a superior option but I would need to know your cab type, if you have running boards or nerf bars, and if you have a factory or aftermarket trailer hitch in order to recommend a set.

expert reply by: Conner L

1

click to enlarge

Answer 1

It sounds like you're looking for TorkLift camper tie downs for your 2017 GMC Sierra 2500 Denali with a short bed. If you've got a factory hitch and no step or running board that extends under the bed of the truck, then the correct TorkLift…

view full answer...

Answer 2

The Brophy Clamp On Camper Tie-Downs #HSBP are not a fitguided item that list specific vehicles that it fits. It is more of a universal item. That being said, the Brophy Clamp On Camper Tie-Downs #HSBP will fit most full-size, non-dually pickup…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 9

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 10

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 11

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Will the Brophy Camper Tie-Downs Part # HSBP Fit a 2015 Chevrolet Silverado 3500

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching