Inside Diameter of Replacement Foam Grip # FP-1001-R

Question

Question:

What is the inside diameter of the foam sold with this part number? FP-1001-R

asked by: Mark F

0

Expert Reply:

The inside diameter of the # FP-1001-R that you referenced is 1 inch.

expert reply by: Jameson C

0

Answer 1

All you need to replace the rubber grip of your RV door handle is the part #FP-1001-R that you referenced. This is designed as a replacement for the Lend a Hand style door handle you have on your 2018 Grand Design Solitude 373FB which is breaking…

view full answer...

Answer 2

The length of the rubber handle part #FP-1001-R is 9-3/4 inches.

view full answer...

Answer 3

To install the Replacement Foam Grip with Hardware for Lend-a-Hand Grab Handles for RVs #FP-1001-R that you referenced will require you to remove the handle from the mounts of the RV. You'll want a ratchet/socket plus a wrench to do this. Once…

view full answer...

Answer 4

The weight rating on your gas strut #372-5300-20 would normally be printed in LBS or NM somewhere on the strut however since your strut's labels have worn off then your best bet is to measure for a new one. In general, the length to choose for…

view full answer...

Answer 5

Unless the force is specifically listed on your current strut, it is unlikely that you will be able to find the exact pressure. There is no standard for the numbers printed on them. For storage compartments, I would recommend a strut with 10-20 lbs…

view full answer...

Answer 6

We do offer the Replacement Hardware Kit #1091 and Replacement Foam Grip with Hardware #FP-1001-R which will allow you to replace the springs on your Lend-a-Hand Extra Large Folding Grab Handle #AM-533. Both kits include the bolts and springs which…

view full answer...

Answer 7

We do offer a replacement monitor power cable, the part number for that is #C-FOS07TAPK-006. Furrion confirms that the cable is compatible with the monitor used by your FOD43TA-BL camera system. I've linked to a product description video for the…

view full answer...

Answer 8

You won't have any issues with this setup. The payload capacity of the truck refers to the capacity of the aluminum truck bed where the pin-weight capacity refers to the amount of additional weight the axles and frame can support. With the hitch…

view full answer...

Answer 9

I believe you are talking about the head pin for the drive head, and there are replacement pins available, but it does depend on the specific awning you have, as the pins are for certain drive heads (we don't have a way of knowing what awning is…

view full answer...

Answer 10

If you are referring to the head pin then yes we do have this available as the Replacement Head Pin for Solera Power Awning Gear Drive Head part #LC266141. That said, you would also want two Replacement Retaining Clips part #LC266137 and one…

view full answer...

Answer 11

We do have just the driver head pin available: - Replacement Head Pin for Solera Power Awning Gear Drive Head #LC93FR This pin will also work for the idler head.

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Inside Diameter of Replacement Foam Grip # FP-1001-R

Product Page this Question was Asked From

Continue Researching