What is Longest Available Thumb Latch for RV Slam Door

Question

Question:

I have one that is 2 inches.Can you get me one that long.

asked by: Olin T

0

Expert Reply:

I wish we had one long enough, but the longest we have is 1-3/4 inches like part # 295-000014 which is measured by the threaded portion.

expert reply by: Jameson C

0

Answer 1

Yes, we sure do! For a stainless steel 1-3/8 inch long thumb turn cam latch cylinder use #295-000013.

view full answer...

Answer 2

The longest thumb cam lock we offer is the Replacement Thumb Turn Cam Latch Cylinder part #295-000014 which measures 1-3/4" long at the threaded portion.

view full answer...

Answer 3

We do not have a slam latch (matching or not) that fits in the door cut out of the Global Link lock that you currently have. Depending on the thickness of the compartment door you may be able to install a Global Link #295-000014 thumb turn cam latch.…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

What is Longest Available Thumb Latch for RV Slam Door

Product Page this Question was Asked From

Continue Researching