Which Hitch for 1999 Ford E150 Passenger Van Sticks Out Least Curt or Draw Tite
Question:
Hi... I am comparing the differences between: Draw-Tite # 75703 vs Curt Trailer Hitch - 13053 Realizing the Draw Tite has slightly more weight capacity, so excluding that... It appears to me, that the Draw Tite is designed for a step bumper, thus sticks out with a standard bumper...which I have... The Curt 13053 is flush.....correct? Do both install the same, or is one easier? Or better??? Thanks!
asked by: Chris
Expert Reply:
I attached two pictures to this page for you to check out. The picture with the hitch that sticks out further and has angled crosstubes is the Draw Tite part # 75703 and the one that is more recessed is the Curt # 13053.
Both fit your 1999 Ford Van and will install the same basically.
Products Referenced in This Question
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 7500 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: Trailer Wiring
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Video: Trailer Hitch Installation - 1994 Ford Van - Draw-Tite
- Shop: Suspension Enhancement
- Shop: Timbren Rear Suspension Enhancement System
- Article: Brake Controller Installation on a Ford Full-Size Van
- Q&A: Recommended Hitch Extender Rated For 600lb Tongue Weight
- Video: Trailer Hitch Installation - 2008 Ford Van - Curt
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Brake Controller
- Q&A: Front and Rear Trailer Hitch Receivers for 1998 Ford Econoline E-150
- Q&A: Is 1990 Ford E-150 Van Hitch Receiver Compatible with 1994 Ford F-150?
- Q&A: Will the Yakima EXO Enclosed Cargo Carrier Fit a 1999 Ford Econoline Van
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - 1 to 2 Axles - Proportional
- Q&A: Brake Controller and 7-Way Installation in 1994 Ford F-150
- Search Results: jounce springs
- Video: Cleaning Weld Nuts for Trailer Hitch Installation
- Video: How to Make a Thread Tap
- Q&A: Difference Between Timbren and SumoSpring Jounce Springs for a 2021 Toyota Tundra
- Search Results: timbren
- Q&A: Spare Tire Clearance of Draw-Tite # 75703 Installed on 2006 Ford E150 Van
- Search Results: trailer hitch
- Video: Choosing the Right Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: hitch
- Video: Tow Ready 4-Pole Mounting Bracket Installation
on Trailer Hitch
