Distance Between Frame Cradle Arms of Thule Passage Trunk Rack

Question

Question:

Interested in the Thule Passage bike carrier and need to know the distance, outside to outside, of the cradle arms. Thanks.

asked by: Bill

1

Helpful Expert Reply:

The outside to outside distance of the cradle arms of the Thule Passage Trunk Rack part # TH910XT is 15 inches.

expert reply by: Jameson C

1

click to enlarge

Answer 1

I have a spare tire mounted bike rack recommendation that will work on the 35 inch tall spare of your vehicle, but the Thule Spare Me part #TH963PRO won't work on tires taller than 32 inches. You should check out the Yakima SpareTime 2 Bike…

view full answer...

Answer 2

I have the perfect trunk mount bike rack for your 2014 Toyota RAV4 that will not even touch that rear spoiler. It is the Hollywood Racks Over-the-Top rack #HRF2 (or #HRF2-3 for 3 bikes). This rack has an additional upper arm piece that moves the…

view full answer...

Answer 3

I spoke to Thule about the Thule Passage Trunk Bike Rack part #TH910XT for your 2019 Volvo S60 and the correct fit dial settings per Thule is 7.

view full answer...

Answer 4

The Thule Range RV Bike Rack #TH9057 spaces each of the cradles 7" on center. Bike racks are typically always measured from center to center on their cradles since not all bikes are the same width so its impossible to know how much space will be…

view full answer...

Answer 5

On the Yakima SpareTime bike rack #Y02598, the instructions state to use the medium tongue with tire widths ranging from 235 to 275. The long tongue is for widths 285 to 12.5. And the short tongue which is what comes pre-installed is for 195 to 235.…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 11

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 12

The Curt High-Low Adapter #C59KR is designed for flat towing only. Curt doesn't even test it for accessories to give it a tongue weight rating. The Roadmaster #RM-048-4 is the most comparable with a distance of 9-5/8" from hitch pin to hitch…

view full answer...

Distance Between Frame Cradle Arms of Thule Passage Trunk Rack

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching