Is Backing Plate Needed for Snap-Loc E-Track Tie-Down Anchor?

Question

Question:

Do you sell a backing plate that fits this hole spacing?

asked by: Maxx

0

Expert Reply:

There is no backing plate we offer with the same 5-1/16" apart on center spacing that the mounting holes of the Snap-Loc E-Track Tie-Down Anchor # SLSZ.

However, these anchors can be mounted onto any smooth surface and an E-track backing plate is not needed to install these anchors; all you need is the Carriage Bolt Hardware for Snap-Loc E-Track Tie-Down Anchors # SLHCBDS-P and you'd be set.

expert reply by: Kyle S

0

Answer 1

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The 205/65-10 and the 20.5 x 8-10 would be very close in size. Assuming that 20.5 is the diameter of the tire and 8 is the width. The Kenda 205/65-10 Bias Trailer Tire with 10 inch White Wheel, #AM3H390, for example, is 8.3 inches wide with a…

view full answer...

Answer 4

That is a good question, and you will need to use three backing plates for each 5 foot section of e-track, so the exact part you will need is the following: - etrailer E-Track Backing Plates w/ Hardware - Qty 3 #e46RR These will fit perfectly with…

view full answer...

Answer 5

Your plan of having an e-track like the part #E19148 attached to two different floor boards in your trailer would be perfect. This will distribute any weight on the e-track to two boards which is a sturdier way to go about it.

view full answer...

Answer 6

Self tappers like the part #SL99FR would work great as they have drill bits on the end which would make it through the metal of your studs and then attach.

view full answer...

Answer 7

Installing the Hinges on your Side-Door Bar Lock Assembly, item #305736, is pretty much up to you and the construction of your trailer. You will need to purchase appropriate hardware to install the Side-Door Bar Lock that you purchased. It is best if…

view full answer...

Answer 8

If it were my trailer I would fasten the E-Track to the support beams under the trailer, either the side to side one or front to back ones, by going all the way through those support beams. E-Track like #E19148 is zinc-coated steel and since the…

view full answer...

Answer 9

The diameter of the outer tube of the Buyers Products A-Frame Jack w/ Support Foot #3370091260 that you referenced is 2-1/4 inches.

view full answer...

Answer 10

My recommendation is the TireMinder A1AS TPMS, #TM79FR this option includes 10 sensors but can be expanded to up to 22 using TireMinder TPMS part #TM-2Brass which are sold in pairs. The system lets you use the monitor or an app on your smartphone as…

view full answer...

Is Backing Plate Needed for Snap-Loc E-Track Tie-Down Anchor?

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching