Availability of Flexco RV Manual Pull Out Step that is 27 inches Wide

Question

Question:

The steps are flexco and when I measured them from inside to inside where they mount are 27 in and the steps are 9 in from Center to Center and 8 in between each step with a total from the top step to the ground are 26 inch

asked by: William D

0

Expert Reply:

The closest Flexco steps we offer to what you mentioned are the Flexco Manual Pull Out Steps part # SMFP-3200L which are a triple step setup that are overall in width 27-1/8 inches.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I checked with Lippert and the part number you mentioned corresponds with the Revolution Kwikee step and the replacement control module you need then is the part #LC363985.

view full answer...

Answer 2

The Ranch Hitch Universal 5th Wheel to Gooseneck Coupler Adapter #AM3139 can potentially work with a recessed gooseneck ball on a flat bed truck, but it's going to depend on just how much the ball is recessed and how much space you have around…

view full answer...

Answer 3

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 4

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs and…

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

For your 4x6 utility trailer, I recommend using the Taskmaster 4.80R12 Radial Trailer Tire part #TT48012C. This tire has a radial ply construction which will be better for the longer highway trips you intended to make. It has a load range C rating…

view full answer...

Answer 9

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 10

National seal 472920 has an inner diameter of 2.25 inches and outer diameter of 3.375. For a replacement, you will want Grease Seal - Double Lip #GS-2250DL or oil seal #10-63.

view full answer...

Answer 11

The modern size equivalent of the 20.5x8-10 that you have currently would be the same size tire that is on the #AM3H340 that you referenced, 205/65-10. As long as the bolt pattern of your current hubs are 4 on 4 inch the wheels of this would bolt up…

view full answer...

Answer 12

The 205/65-10 and the 20.5 x 8-10 would be very close in size. Assuming that 20.5 is the diameter of the tire and 8 is the width. The Kenda 205/65-10 Bias Trailer Tire with 10 inch White Wheel, #AM3H390, for example, is 8.3 inches wide with a…

view full answer...

Availability of Flexco RV Manual Pull Out Step that is 27 inches Wide

Product Page this Question was Asked From

Continue Researching