Replacement Motor and Diagram for Ventline Vanair Trailer Roof Vent
Question:
i have one installed already in my trailer,mud dobbers got in an plugged my fan i turned on now after cleaning out mud.i have removed handle an the screen ,so when i push button it will run if i help turn fan,it turns off ok, it has 13.25 volts to motor. so i figure it needs motor replaced. my question is it looks like hard to remove fan off motor shaft cause i pulled on it from on top.and if i do get it off it mat be hard to align the shaft on fan spline.so i thought instead of wasting money getting just a new motor,i get complete fan kit for $65.00 an now my question is can i disconnect the motor wires after loosening the handle and removing the screen from the bottom of trailer,then go up top remove black cover with 2 screws,then how do i get the fan and the motor out as a assembly so i can slip back in a new motor an fan still attached from factory? looks like maybe by pushing from bottom up the two brackets that the handle is attached to push it all the way up with old fan an motor attached up an out.reversing new install of motor an fan,the hook wires finish install screen an handle. hope you understand my explanation. thank so much
asked by: Tom M
Expert Reply:
The correct replacement motor for the Vanair Roof Vent part # VP-543SP that you referenced is the part # BVD0218-00. I attached a diagram that covers how it all comes apart for you to check out which should help you in getting out the old vent to install the new one.
I also attached install instructions for the motor for additional reference although you may not need them.
Products Referenced in This Question
Replacement 12V DC Motor for Ventline, Ventadome, and Vanair Fans
- Accessories and Parts
- RV Range Hoods
- RV Vents and Fans
- Range Hood
- Motor Parts
- Motor
- Ventline
more information >
Product Page this Question was Asked From
Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- 2-3/8 Inch
- 12V Fan
- Plastic
- Tinted
- Ventline
more information >
Continue Researching
- Shop: Replacement 12V DC Motor for Ventline, Ventadome, and Vanair Fans
- Shop: Replacement Fan Blade for Ventline Vanair Trailer Roof Vent
- Shop: Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke
- Video: Review of Snap-Loc Tie Down Anchors - Trailer Tie-Down Anchors,Track Systems and Anchors - SLCTDAK
- Video: Ventline Replacement 12-Volt DC Fan Motor Review
- Video: Review of Ventline RV Vents and Fans Replacement Motor - BVD0218-00
- Shop: Tailgate
- Shop: Truck Bed Tailgate Assist
- Search Results: ventline vp
- Video: Review of Ventline Replacement Fan Blade Vanair RV Roof Vent - BVD0217-00
- Search Results: water heater bypass kit
- Search Results: dometic water heater
- Shop: Replacement Gear Motor with Pinion Gear for Ventline Ventadome Trailer Roof Vent
- Shop: Demco Recon Gooseneck-to-5th Wheel Trailer Hitch Adapter for Recessed Ball - Single Jaw - 21,000 lbs
- Shop: Ventline Ventadome Roof Vent w/12V Fan and Wall Switch - Powered Lift - 14-1/4" - Smoke
- Shop: Snap-Loc Tie-Down Anchor Kit - 1,000 lbs
- Search Results: airstream
- Video: Review of Ventline RV Roof Vent - Low-Profile Round Fan - VP-543SP
- Shop: Roof Rack
- Q&A: Recommended Roof Rack for Little Guy Silver Shadow Tear Trailer
- Q&A: Dometic Over-the-Range Microwave DOTR12CB Replacement Recommendation
- Q&A: Is Replacement Fuse Needed for the Ventline 12V DC Motor BVD0218-00
- Q&A: Installation of Replacement Push-Button Switch for Ventline Roof Vent
- Article: Trailer Wiring Diagrams
- Search Results: 44649
- Shop: Trailer Hitch
- Video: B and W Companion OEM 5th Wheel Hitch Installation - 2020 GMC Sierra 3500
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Shop: Trailer Wiring
- Search Results: dust cap