Recommended Trailer Hitch for 2017 Land Rover Evoque HSE Dynamic
Question:
I will install whatever hitch I choose on my 2017 Range Rover Evoque HSE Dynamic. The Dynamic trim level includes what RR calls Dynamic Body upgrades, and while Im not sure, I think my rear fascia extends further under the body than the model in your photos. So my question is, will I have to modify do any cutting the fascia? Have you done an install on a 2017 HSE Dynamic yet?
asked by: Fred O
Helpful Expert Reply:
The Draw-Tite Max-Frame Trailer Hitch Receiver # 75227 referenced in your question is confirmed to fit your 2017 Land Rover Evoque HSE Dynamic model. I confirmed this with my contact at Draw-Tite.
When installing the hitch, you will need to trim the rear fascia and heat shield (approximately 3-7/8 inches wide by 1 inch high from the bottom of the fascia - see attached image). Because the custom hitch will use existing holes in the Land Rover's frame, you will not need to do any drilling.
I have attached the complete written instructions that you can also take a look at.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: Brake Controller
- Video: Choosing the Right Brake Controller
- Video: Draw-Tite Max-Frame Trailer Hitch Installation - 2016 Land Rover Evoque
- Video: Draw-Tite Max-Frame Trailer Hitch Installation - 2015 Land Rover Evoque
- Video: Choosing the Right Trailer Wiring
- Search Results: 44649
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 25580
- Shop: Grease Seals 10-36 (pair)
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Shop: Dust Cap for Kodiak Disc Brake Kit
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Shop: Fifth Wheel Hitch
- Video: Roadmaster Automatic Battery Disconnect Installation - 2020 GMC Sierra 1500
- Search Results: 68149
- Search Results: dust cap
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Video: Lippert Solera Slider Slide-Topper Review
- Shop: Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Article: Brake Controller Installation: Starting from Scratch
- Shop: Gooseneck Hitch
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
Jerry
6/13/2020
Looking to buy this trailer hitch for a 2016 Land Rover - Range Rover evoque. Do you know rough height of the trailer hitch. Looking to buy a small Yamaha boat with a shorelandr trailer and want to make sure the boat would be leveled.