Timbren Rear Suspension Enhancement System for a 2003 Chevrolet 2500 HD Silverado

Question

Question:

Will this kit fit my 2003 silverado, 2500 HD long box truck. if not please let me know which one to order. thanks.

asked by: Dwayne

0

Expert Reply:

The correct kit for your 2003 Silverado, 2500 HD with long Bed, is the Timbren Rear Suspension Enhancement System, # TGMRCK25S, which is the correct kit for 2 and 4 wheel drive models. We have a video installation that should be helpful and installation instructions for you to look over, see links.

The kit you referred to is designed for 2500 Service vehicles only.

Another option for your vehicle is the SumoSprings Custom Helper Springs Kit, # SSR-201, which is a good option if your truck is a work truck that is loaded constantly with tools and supplies. I have attached instructions for this system also.

expert reply by: Robert G

0

Answer 1

The only Timbren kit that fits the 1500, 2500, and 3500 models of the 2006 Chevy Silverado pickups is the Kit #TGMRTT35S for severe service vehicles. Aside from that all of the other kits are model specific. For your 3500 you'll need the kit…

view full answer...

Answer 2

The best option we have for your 2004 GMC Sierra 2500HD with truck bed camper is the Timbren Rear Suspension Enhancement System part #TGMRTT35S. This system is specially designed for vehicles with truck bed campers and will do an excellent job of…

view full answer...

Answer 3

You would get suspension support for your 2003 Chevy Silverado 2500HD with a Timbren setup but the ride quality will be pretty harsh so I have a different route I'd recommend first with the RoadActive Suspension System part #RAS3611-CHD for if…

view full answer...

Answer 4

The Timbren Rear Suspension Enhancement System part #TGMRTT35S is a great option for a 2005 GMC Sierra 3500 with truck bed camper. They are actually designed for constant loads like this so they will provide excellent support. They are also…

view full answer...

Answer 5

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 6

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 7

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 8

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Timbren Rear Suspension Enhancement System for a 2003 Chevrolet 2500 HD Silverado

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching