Recommendation for 16 Inch X 6 Inch White Steel Wheel with 8 on 6-1/2 Inch Bolt Pattern

Question

Question:

I am looking for a white steel 16x6 wheel with 8x6.5 inch bolt pattern. Its for a 2012 Kaufman 7 ton trailer. Can you suggest.

asked by: Albert A

1

Helpful Expert Reply:

We do have a nice selection of 16 inch x 6 inch white steel wheels available that feature the 8 on 6-1/2 inch bolt pattern you are needing.

I recommend specifically looking at the Dexstar Steel 8-Spoke Trailer Wheel # AM20750. This 16 inch x 6 inch wheel features a sleek 8-spoke design and a white powder coat finish on both sides of the wheel. Its 8 on 6-1/2 inch bolt pattern will match right up to your hubs and is made right here in the USA.

I have attached a couple short video demonstrations on these two wheels so you can get an even closer look.

expert reply by: Chris R

1

Answer 1

The Better Bath 24" x 40" RV Bath Tub - Left Drain - Parchment #LC209388 is 40 inches long and 24 inches wide from outside lip to outside lip and is 10-1/2 inches deep. The lip is 1-3/4 inches tall. The internal length of the oval…

view full answer...

Answer 2

We have just what you need! The Better Bath RV Bathtub part #LC209388 is 40 by 24 inch and is in the color parchment just like you are wanting.

view full answer...

Answer 3

We have a couple different size bathtubs available that feature a left hand drain like what you are needing. The Better Bath - Parchment #LC209388 that you were looking at measures 40 inches long and 24 inches wide. This size is also available in…

view full answer...

Answer 4

I went out to our warehouse to take a look at the Lippert Better Bath RV Bath Tub #LC209388. The 24 inch x 40 inch measurement listed does refer to its overall, outside to outside dimensions. From the center of the drain hole to the inside of the…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 8

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 9

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 10

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

The 12 inch tires that we carry are rated for 65 miles per hour. Any faster than that for extended periods and the excessive heat build up will cause tire failure. To get a tire with a higher speed rating you would have to go up in size. That also…

view full answer...

Recommendation for 16 Inch X 6 Inch White Steel Wheel with 8 on 6-1/2 Inch Bolt Pattern

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching