Disc Brake Kit Recommendation for Spindle that Measures 1 inch in Diameter

Question

Question:

Thank you for the reply Your recommendation of the K2HR2D was good but will not work as my spindle which has a L68149 bearing with a 1.378 ID Thru research on your web site I have found out that my outer brg L44649 takes the same race as the L68149 Therefore the T4843100 kit should work for this application Please check on my findings to concur Again many thanks Hope to order soon on your concurrence

asked by: John

0

Expert Reply:

What is the diameter of the spindle where the inner bearing rides? If it is also 1 inch we have the Kodiak disc brake kit part # K2HR2D that will fit the spindle. Otherwise if you have a different dimension there we wouldn't have a fit.

expert reply by: Jameson C

0

John

3/29/2018

Thank you for the reply Your recommendation of the K2HR2D was good but will not work as my spindle which has a L68149 bearing with a 1.378 ID Thru research on your web site I have found out that my outer brg L44649 takes the same race as the L68149 Therefore the T4843100 kit should work for this application Please check on my findings to concur Again many thanks Hope to order soon on your concurrence

Reply

Jameson C.

3/29/2018

Based on the numbers you just listed you have a 3,500 lb spindle on your trailer and the Titan Disc Brake Kit # T4843300 that you referenced is going to fit and work well.

Reply

Answer 1

I have information that you might find helpful, but we do not have a schematic drawing of these parts available. With that said, if you've got a spindle from a Hyundai Elantra on this buggy then you're most likely only going to be able use…

view full answer...

Answer 2

I spoke with Kodiak and they were able to tell me that the Kodiak 10" Rotor #KR10D has a .930" or 22.62mm thick braking surface, and has an overall thickness of 2.337" or 59.4mm. Attached is a product overview video, as well as a…

view full answer...

Answer 3

In order to find the correct replacement hub and spindle you will need to know the capacity of your axle along with the bearings you currently have. In order to find the size of the bearings you can look for part numbers on your existing bearings. If…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 9

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 10

Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Disc Brake Kit Recommendation for Spindle that Measures 1 inch in Diameter

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching