Replacement Head for Reese SC Weight Distribution System

Question

Question:

pro series sc replacement head i have pictures of it. do you have the replacment part?

asked by: Dale N

1

Helpful Expert Reply:

It sounds like you're looking for a replacement head for a Reese SC weight distribution system If this is correct then the part you need is # RP58167.

If you'd like you can reply with your pictures and I'll verify if this is the same or not.

expert reply by: Charles S

1

Answer 1

Thank you for the pictures. From them I can tell that you have a Reese trunnion style weight distribution system. Which makes the Replacement Head for Reese Weight Distribution System #RP58167 the correct replacement head for your system.

view full answer...

Answer 2

The spacing between the two bolts of the Reese replacement weight distribution head, part #RP58167, are about 3-3/4 inches apart, center on center.

view full answer...

Answer 3

The Trunnion Latch Pins, #58025 are not included with the #RP58167 Replacement Weight Distribution Head. According to our friends at Reese, this head is compatible with your older spring bars that use the latch pins, but they will not fit quite as…

view full answer...

Answer 4

Our Draw-Tite weight distribution systems recommend tightening the bolts on the head to 300 lbs/ft.

view full answer...

Answer 5

You won't have any fitment issues with the Curt Trailer Hitch Receiver - Custom Fit - Class V Commercial Duty - 2-1/2" #C15809. I've attached a photo of this installed so you can see the exhaust fit with this hitch will allow plenty of…

view full answer...

Answer 6

According to Reese, the Replacement Head for Reese Weight Distribution System #RP58167 is interchangeable with the 62167. You can use this to replace the head on your weight distribution system.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Yep, so long as your 2024 Subaru Crosstrek Wilderness is not a hybrid both the Curt and etrailer hitches will fit: - Curt Trailer Hitch Receiver #C13382 - etrailer Trailer Hitch Receiver #e98912 The only difference besides price is the finish; the…

view full answer...

Answer 10

Yes you are - all 5th wheel hitches are going to require some type of rails in order to be used. So you'd need #DM8552016-71 for your 2006 Dodge Ram.

view full answer...

Answer 11

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 12

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Replacement Head for Reese SC Weight Distribution System

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching