Is the 58167 Reese Replacement Head The Same as the 62167 Weight Distribution Hitch Head

Question

Question:

I am wondering if Reese PTNR 58167 is the same as 62167? Please advise

asked by: Drennen F

0

Expert Reply:

According to Reese, the Replacement Head for Reese Weight Distribution System # RP58167 is interchangeable with the 62167. You can use this to replace the head on your weight distribution system.

expert reply by: Robin H

0

Answer 1

Our Draw-Tite weight distribution systems recommend tightening the bolts on the head to 300 lbs/ft.

view full answer...

Answer 2

It sounds like you're looking for a replacement head for a Reese SC weight distribution system If this is correct then the part you need is #RP58167. If you'd like you can reply with your pictures and I'll verify if this is…

view full answer...

Answer 3

You won't have any fitment issues with the Curt Trailer Hitch Receiver - Custom Fit - Class V Commercial Duty - 2-1/2" #C15809. I've attached a photo of this installed so you can see the exhaust fit with this hitch will allow plenty of…

view full answer...

Answer 4

The spacing between the two bolts of the Reese replacement weight distribution head, part #RP58167, are about 3-3/4 inches apart, center on center.

view full answer...

Answer 5

The Trunnion Latch Pins, #58025 are not included with the #RP58167 Replacement Weight Distribution Head. According to our friends at Reese, this head is compatible with your older spring bars that use the latch pins, but they will not fit quite as…

view full answer...

Answer 6

The Reese Replacement Head, part #RP58167 is designed to work with Reese systems that have trunnion bars. Since manufacturers do not test their components with other manufacturer's parts, I cannot guarantee this replacement head would work with…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Is the 58167 Reese Replacement Head The Same as the 62167 Weight Distribution Hitch Head

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching