Length of Spring Bars on Curt TruTrack 17500 Weight Distribution System

Question

Question:

Hi, Im trying to determine if the the Curt TruTrack 17500 will fit my trailer. I only have an opening on my trailer from 25-29inch along the A-frame from the center of the ball propane mount is a fixed welded design. The Curt 17500 recommends setting the frame brackets 4 inches from the end of the trunnion bar. Therefore the most obvious question is: What is the length of the trunnion bar? Could you measure and let me know?

asked by: Al

0

Expert Reply:

I checked and the spring bars of the Curt TruTrack Weight Distribution System # C17500 are 35" long and 1-1/4" wide and based on your photo and the necessary positioning of the brackets. I do have a solution which could work for you, however. Since the TruTrack you asked about would be for a 900 lb total tongue weight I assume that you need a system with that tongue weight rating. The Equal-i-zer # EQ37120ET has brackets that can be positioned 27" - 32" from the center of the coupler. It features 4-points of friction sway control which prevent your trailer from swaying and create a level ride. It comes with everything you need for installation but it is recommended you use thin-walled socket # EQ70-00-4800 for installation of the hitch ball.

I've added links to video reviews of the Equal-i-zer for you to take a look at.

expert reply by: Kyle S

0

click to enlarge

Answer 1

You upgraded your weight distribution from the Curt short-arm system, part #C17322, to the Curt TruTrack, part #C17500, which is much better system but it's still rated too high most likely. It all depends on the loaded trailer's…

view full answer...

Answer 2

A quality wheel bearing grease like #L11465 or the bearing grease you're already using would work just fine. You'll want to grease the trunnions by using the grease zerk and also brush some grease on the ball bearings above the trunnion as…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

Thanks for the picture! The Curt TruTrack 2P Weight Distribution System w/ Sway Control item #C69JR will work with your 7,000 lbs Jayco 267BH. The Curt TruTrack has an 800 lbs to 1,000 lbs tongue weight range. The built in sway control will help to…

view full answer...

Answer 8

Generally speaking, it is not advisable to reverse a trailer when using a weight distribution system. The system won't blow up but if you reverse at too sharp an angle then you can damage the head so you have to do so in a pretty straight line or…

view full answer...

Answer 9

Most manufacturer's say 10% under your truck's capacity but our recommendation is to go between 20%-25% below. So you would want to go no higher then 1,992 lbs - 1,867 lbs of tongue weight with your 2020 Chevrolet Silverado 2500. I have…

view full answer...

Answer 10

Hey Dennis, we have a replacement 7-way plug with the part #A7WCB which would work great to replace your damaged one. I attached a diagram for 7-ways for you to check out as well.

view full answer...

Answer 11

The Electric Jack w/ Footplate and 7-Way Plug #EJ-3527-BBX uses a 7-way RV-style plug. I have included a diagram that shows the pin-out for RV style 7-way plugs. This will show you what each pin does. I have also listed the functions below and linked…

view full answer...

Answer 12

Hi Emily, Before buying anything you'll want to verify that both the Pilot and the trailer hitch installed on it are rated for use with a weight distribution hitch (WDH). From what I can see Honda does not recommend it because it can shift the…

view full answer...

Length of Spring Bars on Curt TruTrack 17500 Weight Distribution System

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching