Options for Spindle With Zerk Fitting That has Snapped Off
Question:
My zerk grease fitting has snapped off. I have tried all removal tools, and have been unsuccessful. Easy out, drill bits, is there a part I can replace, or is it in the entire axle assembly?
asked by: Eric H
Expert Reply:
If your zerk fitting has snapped off your spindle and you cannot remove the remaining pieces then you can replace the entire spindle. Should you not know the model of spindle you have what you can do is use a digital caliper like # PTW80157 to measure the spindle and find the correct replacement.
We do recommend having a qualified welder remove your old spindle and replace it with a new one. I've added a link for you with our selection of E-Z Lube spindles for you to take a look at as well.
Products Referenced in This Question
4" Carbon Fiber Digital Caliper
- Hand Tools
- Measuring and Layout Tools
- Digital Calipers
- Carbon Fiber
- Performance Tool
more information >
Product Page this Question was Asked From
#84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axle - 1-3/4" Diameter
- Trailer Spindles
- EZ Lube Spindle
- 1-3/4 Inch Diameter
- Round
- For 3500 lb Axle
- TruRyde
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Bearing Kit, 15123/ 25580 Bearings, 10-36 Seal
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 12" - Left/Right Hand - 5.2K to 7K
- Search Results: 5200 axle
- Search Results: 5200 lbs axle
- Search Results: brake pads
- Shop: Dexter Nev-R-Adjust Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 6K
- Q&A: Will Overheating a Trailer Hub Damage the Spindle
- Search Results: 5000 lb axle with brakes
- Search Results: 25580
- Search Results: akhd6556ezk
- Shop: Electric Trailer Brake Assembly - 12" - Left Hand - 5,200 lbs to 7,000 lbs
- Shop: Electric Trailer Brake Assembly - 12" - Right Hand - 5,200 lbs to 7,000 lbs
- Shop: etrailer Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 5,200 lbs to 7,000 lbs
- Shop: Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 5-1/2 - Pre-Greased
- Q&A: Are 12" Electric Trailer Brake Assemblies Available Individually And Not As A Set?
- Search Results: bearing 25580
- Q&A: Trailer Hub that Uses Bearing # LM67048 for Inner and Outer
- Q&A: The Difference of Single Lip And Double Lip Grease Seals
- Q&A: Can a Hub with Outer Bearing 15123 and LM67048 Both Fit Same Spindle
- Article: Trailer Wiring Diagrams
- Video: Choosing the Right Trailer Wiring
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Shop: Trailer Hitch
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Trailer Wiring
- Article: Most Popular Wheel Bearings
- Video: Choosing the Right Brake Controller
- Shop: Fifth Wheel Hitch
- Video: Roadmaster Automatic Battery Disconnect Installation - 2020 GMC Sierra 1500