What Is Thread Size Of Curt Anti Rattle Kit # F-315

Question

Question:

What is the thread size of the pin on the CURT Anti Rattle Kit F-315. Thanks....

asked by: Eric

0

Expert Reply:

I contacted our representative at CURT and he informed me that the CURT Trailer Hitch Anti-Rattle Kit, part # F-315, has standard 1/2 inch threads.

I have linked an FAQ on Anti-Rattle hitch pins.

expert reply by: Reno H

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

You are on the right track. The only way we have that will allow you to use the Thule T2 Pro Xtr Bike Platform Rack part #TH69TX with the 2.5" receiver tube opening on your truck would be with adapter. For this, I recommend the Brophy Hitch…

view full answer...

Answer 4

To keep your back end from squatting, I recommend the Coil SumoSprings Custom Helper Springs for Coil Spring Suspension item #CSS-1094R. These insert into your rear springs and keep your suspension from being pushed down by the weight of your…

view full answer...

Answer 5

I recommend the Roadmaster Dual Hitch Receiver Adapter, 10" Drop/Rise item #RM-077-10. This adapter was designed for this type of set up. Your Jeep Rubicon and Swagman E bike rack weigh well below the 10,000 lbs maximum capacity of this hitch. I…

view full answer...

Answer 6

Thule doesn't make a round bar. They are known for square bars and more recently aero shaped bars. Yakima on the other hand is more known for round bars like the part #Y00410 for a quantity of 2 66 inch round crossbars.

view full answer...

Answer 7

For your 2020 Chrysler Voyager that has the seventh VIN digit as D the correct trailer wiring install harness is the Curt #C56399.

view full answer...

Answer 8

The Curt Trailer Hitch Receiver #C11431 is designed for and confirmed to fit the Hatchback ST. There will be drilling required for installation, exhaust must be temporarily lowered for installation and access holes may need to be enlarged by…

view full answer...

Answer 9

To reduce the rattle and wobble on your hitch when you are using your bike rack we have a couple options you can check out. The Roadmaster Quiet Hitch, part #RM-061-125 will work great if your trailer hitch has a lip on the end of the receiver. I…

view full answer...

Answer 10

I have some information that will help us determine if the air bags included with the Air Lift Ride Control Helper Springs, #AL59561, will work for you, however, we have not received any complaints of these air bags being too tall or causing fit…

view full answer...

Answer 11

For your application you're going to need the GasStop Emergency Propane Shut-Off Valve Gauges w/ GasGear 12" Propane Hoses #GS49FR. This comes with 2 of the GasStop valve/gauges and 2 pigtails that tie into a dual regulator like the MB…

view full answer...