Availability of Replacement Brake Shoes and Other Parts for Hydraulic Trailer Brakes

Question

Question:

I have a trailer with hydraulic surge brakes. I am looking for replacement brake shoes, but have only been able to locate the entire brake assembly on the website. Do you sell brake shoes only?

asked by: Jack

0

Expert Reply:

We sell both complete hydraulic brake assemblies (and electric drum brakes too, of course) as well as individual replacement parts like shoes, springs and wheel cylinders for hydraulic brakes. We also offer parts for electric brakes including magnets.

I linked for you our pages for both complete hydraulic brakes and for individual hydraulic brake replacement parts. Among the individual parts shown are pads/shoes. Just click on the category of parts you need.

Keep in mind that brake parts are handed - they are for a left-hand brake like part # BP04-164 or a right-hand brake like # BP04-162. The pads also differ based on the drum/size they fit. The two most popular drum brake sizes are 10 x 2-1/4-inch and 12 x 2-inch sizes.

expert reply by: Adam R

0

Answer 1

If you have Dexter Free Backing assemblies you would need part #bp04-162 for the right hand side and part #bp04-164 for the left hand side. This is the only kit we have for the 12 by 2 inch Dexter asemblies.

view full answer...

Answer 2

While we do have a parking brake solution for you, unfortunately you can't add parking brakes to a set like the Hydraulic Brake Kit #AKFBBRK-7 that doesn't come with parking brake levers. Instead you need the kit #T2351300-200 that has…

view full answer...

Answer 3

Yes, for our brake assemblies that have parking brake capabilities like the Dexter Hydraulic Brake Kit w/ Parking Brakes - Uni-Servo #T2351300-200 that you referenced we do have hand brake levers to activate them with the part #T2385200. This comes…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 7

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Availability of Replacement Brake Shoes and Other Parts for Hydraulic Trailer Brakes

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching