Jack Handle # MJ-1000B-HD Diameter and Radius

Question

Question:

Can you give me the diameter of the round stock of this jack handle. I would be using it for a project I am building that will require 1/2” diameter. Other dimensions would also be helpful. Thanks

asked by: Randy

1

Helpful Expert Reply:

The diameter of the Replacement Sidewind Handle # MJ-1000B-HD that you referenced is 1/2 inch. The radius of the handle is 7 inches.

expert reply by: Jameson C

1

Answer 1

This particular Dutton-Lainson jack is made in China. Some of their other jacks are U.S. built. The Dutton-Lainson Model 6800, part #DL22580 is built in the U.S.

view full answer...

Answer 2

The Dutton-Lainson #DL22300 is proudly made in the USA.

view full answer...

Answer 3

In order to remove a welded-on trailer tongue jack you will need to cut off the old welds to release the mounting bracket. This can be done using an angle grinder. The jack can then be replaced with another welded-on option such as the Fulton Marine…

view full answer...

Answer 4

The Dutton Lainson jacks are all made in America. I attached a link to a page that has all of the Dutton Lainson trailer jacks we offer. A very popular option is the part #DL22300 which is made in America.

view full answer...

Answer 5

Sometimes a substitute part like a jack handle will fit on another brand of jack but we do not test items in this way since there are so many possible combinations. I did check the dimensions of an alternate handle, part #BD500171, and found that the…

view full answer...

Answer 6

I checked the Dutton-Lainson website but a complete engineering diagram of this item is not available, so I took a piece from inventory and measured the mounting hole spacing. All eight mounting holes on the Dutton-Lainson Sidewind Swivel Jack…

view full answer...

Answer 7

In order to find if the mounting holes on the Swivel Marine Trailer Jack with Caster Wheel - Bolt On - Sidewind - 10" Travel - 1,000 lbs #DL84MR will line up with your existing bracket you will need to take some measurements. See the dimensional…

view full answer...

Answer 8

Dutton Lainson makes a galvanized, USA-made swivel jack #DL22300 that can work attached to the side of the trailer tongue. This is a popular option for trailers that will see saltwater so it would work well for you. It has a tongue weight lifting…

view full answer...

Answer 9

I went out to the warehouse and pulled one of the Pro Series Snap-Ring Swivel Jacks, #PSEJ10000101, to measure for you. I added dimensions to a photo I took of the mounting plate for you to use to see if the mounting pattern will match up to your…

view full answer...

Answer 10

We have several trailer jacks that have a wheel that allows you to move your trailer around when uncoupled fron the hitch. When choosing a trailer jack you will want to find one that has the capacity to handle the tongue weight of your trailer. I…

view full answer...

Answer 11

Not all trailer jack snap ring mounts are made to the same dimensions. Some are bigger than others. We had customers come back and tell us that the Fulton snap ring trailer jack like part #FTJ120W0301 fits on the same snap ring as the Atwood jacks.…

view full answer...

Answer 12

Based on the picture you submitted the Fulton Marine Jack part #FXP100W0301 that you referenced would be exactly what you'd need and would bolt right up to the mount you have on the trailer frame.

view full answer...

Jack Handle # MJ-1000B-HD Diameter and Radius

Product Page this Question was Asked From

Continue Researching