Trailer Jack that Can Fit on Same Snap Ring Mount as Atwood Jack
Question:
I have an Attwood MPD80274 jack that was damaged. It is welded on, and I am looking to just remove the snap ring to install a new jack. Are the ring sizes the same ?
asked by: Isaac
Expert Reply:
Not all trailer jack snap ring mounts are made to the same dimensions. Some are bigger than others. We had customers come back and tell us that the Fulton snap ring trailer jack like part # FTJ120W0301 fits on the same snap ring as the Atwood jacks. This has a snap ring pilot hole that measures 2.313 inches.
Worse case scenario this comes with a new weld on mount.
I attached a review video for this for you to check out as well.
Product Page this Question was Asked From
Fulton Round, Snap-Ring Swivel Marine Jack - Weld On - Sidewind - 10" Lift - 1,200 lbs
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Is There a Replacement for a Shelby Jack 5856A That Uses Existing Bracket
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Trailer Jack Recommendation for Shelby # 5856A
- Q&A: Recommendation to Replace Shelby 5756A Trailer Jack
- Q&A: Replacement Jack for Bulldog Model 130 Marine Jack
- Q&A: Replacement Parts and Winch for a Profile 2000 Hand Winch
- Article: Best Boat Trailer Jacks
- Article: Trailer Jacks
- Article: Trailer Maintenance Schedule
- Article: Pintle-Hitches
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements