Can Winch Snatch Block Increase Weight Capacity of Winch
Question:
Ok I have a winch and yes it came from the manufacturer, however it is scary to be near the cable as it goes up and down. It’s a single cable and yes I use it to get the door near the closed point and then just push it the extra few inches and close the handles on door. I learned this method as my friend used his and damaged the ceiling as he pulled it completely closed. My question is how can I use a snatch block as I see this method used on vehicle recovery. A tow driver said it reduced the weight and increased the pulling power. Will I have to purchase a new winch or is there a way to reconfigure the current system to use a snatch block or does it make a difference?
asked by: Ken
Expert Reply:
Using a snatch block like the # BDW20049 you can basically double the capacity of the winch you are using. You should note that when doing this you end up slowing down the speed of the jack by 50 percent. The same amount of weight will be present on the cable, but if you are worried about the location of where you have the winch mounted it would have 50 percent less of a load on it.
If you check out the lovely picture I edited you'll see how a winch and pulley/snatch block need to be set up to gain the additional capacity.
Product Page this Question was Asked From
Bulldog Winch Snatch Block - Gold Zinc Coated - 19,000 lbs
- Accessories and Parts
- Electric Winch
- Pulleys and Snatch Blocks
- Snatch Block
- Bulldog Winch
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Dutton-Lainson Hand Winch - TUFFPLATE Finish - 2 Speed - Direct Drive - 3,200 lbs
- Video: Dutton-Lainson Trailer Winch DL24104 Review
- Shop: Steel Mod Silver Trailer Wheel - 15" x 5" Rim - 5 on 4-3/4
- Q&A: Winch and Strap Recommendation for Use on Boat Trailer for Bayliner Capri 2150
- Q&A: Trailer Winch Recommendation for 2003 Bayliner 24 ft
- Q&A: Hand Winch for Floating Dock that Can Accept 3/8 inch Wire Rope
- Q&A: Mounting Bolt Pattern For Dutton-Lainson Hand Winch # DL15440
- Shop: Hand Winch Cable with Safety Hook 1/4" Diameter x 50' Long - 3,500 lbs
- Shop: Hand Winch Strap with Safety Hook, 2" Wide x 25' Long - 4,000 lbs.
- Shop: Hand Winch Strap with Safety Hook, 2" Wide x 20' Long - Extra Heavy Duty - 4,800 lbs.
- Shop: Fulton Galvanized Winch Cable with Hook - 50' x 7/32" - 5,600 lbs
- Shop: Hand Winch Cable with Safety Hook 5/16" Diameter x 25' Long - 2,500 lbs.
- Q&A: Recommended Pulley Block To Use With Offset Winch On Trailer
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: 25580
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Most Popular Wheel Bearings
- Search Results: gooseneck coupler
- Shop: Trailer Wiring
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Video: Choosing the Right Brake Controller
- Search Results: trailer jack
- Shop: Brake Controller
- Shop: Gooseneck Hitch
- Article: How to Measure for Trailer Hitch Drop
- Video: etrailer Enclosed Trailer Transition Plate Review
- Search Results: safety chains
on Accessories and Parts
