Foot Plate Pivot Range for TorkLift GlowStep All Terrain Landing Gear TLA8000

Question

Question:

How much do the landing gear bottom feet pivot angle? From vertical, how much can the foot pivot front or back?

asked by: Charles C

1

Helpful Expert Reply:

The pivoting bottom plate on the TorkLift GlowStep All Terrain Landing Gear # TLA8000 can move approximately 30-degrees in each direction from level. I went to our warehouse to see this kit for myself.

Height is adjustable and weight rating is 1400-lbs per pair.

expert reply by: Adam R

1

click to enlarge

Answer 1

Which holes are you talking about specifically on the steps?

view full answer...

Answer 2

Yes, since the mounting bracket for the TorkLift GlowStep Camper Scissor Steps #TLA7805 can be mounted under your door this will reduce the distance for that last step into your camper. I went out to the warehouse and found that the mounting…

view full answer...

Answer 3

Those loops you see on the side of the brackets on the #TLA8000 are for the TorkLift GlowGuide Handrail #TLA7621. I attached a picture that shows how the handle attaches to those loops.

view full answer...

Answer 4

I recommend the TorkLift GlowStep Camper Scissor Steps - 5 Steps - Aluminum - 20" Wide - 325 lbs Item #TLA7805. You can bolt this to the outside of your camper just under the door frame and it will fit your 45" entry height. There…

view full answer...

Answer 5

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side.…

view full answer...

Answer 6

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 7

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 8

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 9

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 10

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 11

A cover being installed on your spare tire would not prevent the Swagman Bike Rack part #S80501 from installing. The rack would still fit and work well. You might still compare the dimensions in the picture I attached with you spare tire so that you…

view full answer...

Answer 12

We have one option that will work for you. The Trailer Hub and Drum Assembly - 4,400-lb E-Z Lube Axles - 10" Diameter - 6 on 5-1/2 #8-407-5UC3-EZ uses inner bearing #L68149 and outer bearing #LM67048 so it would work perfectly on your spindle.…

view full answer...

Foot Plate Pivot Range for TorkLift GlowStep All Terrain Landing Gear TLA8000

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching