Northstar 850 SC Camper Step Recommendations

Question

Question:

I have a brand new northstar 850 SC on a ford f-150 2019 that as no steps I need some steps to get in

asked by: Jim D

0

Expert Reply:

I recommend the TorkLift GlowStep Camper Scissor Steps - 5 Steps - Aluminum - 20" Wide - 325 lbs Item # TLA7805.

You can bolt this to the outside of your camper just under the door frame and it will fit your 45" entry height. There is also a hand rail sold separately # TLA7621.

expert reply by: Kevin C

0

Answer 1

The pivoting bottom plate on the TorkLift GlowStep All Terrain Landing Gear #TLA8000 can move approximately 30-degrees in each direction from level. I went to our warehouse to see this kit for myself. Height is adjustable and weight rating is…

view full answer...

Answer 2

Yes, since the mounting bracket for the TorkLift GlowStep Camper Scissor Steps #TLA7805 can be mounted under your door this will reduce the distance for that last step into your camper. I went out to the warehouse and found that the mounting bracket…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 6

It is too small of a space to fit the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 4 Steps - 375lbs - Black Bracket Item #TLA7834 but you can instead mount it to the bumper of your camper like in the attached picture.

view full answer...

Answer 7

Hey Al, this is a great question but since you have free-backing plates now you would never need to mess with the manual lock out of your Atwood coupler.

view full answer...

Answer 8

Sounds like you'd want to go with a removable scissor setup like the Brophy Camper Steps part #AS24 which will need to be taken off it's mounting bracket between uses. This will give you total access to your trailer hitch when needed.

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

Are you basically asking how much length would this coupler add to the tongue of your trailer?

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...