Installing a Brake Controller on 2011 Chevy Express Passenger Van

Question

Question:

I have a journey 52650 brake controller that I just got for my birthday and want to install it myself on my 2011 chev 3500 express van PASSENGER and want to buy the quick connect at the controller and also BUY the quick connect at the rear tailights to a 7 way flat plug I already just barely bolted on. no wires attached yet. WHAT BRAND AND PART NUMBER OF THE QUICK CONNECT HARNESS DO I NEED?

asked by: Steve

0

Expert Reply:

There is nothing specifically referred to as a quick connect, but in order to install a brake controller you will need a 4-way harness # 118392 which plugs in behind the trim panels in the cargo area on you 2011 Chevy Express Van. You will then need to install the Universal Installation Kit for Trailer Brake Controller # ETBC7 which will include a 7-way plug.

I've added links to reviews of these products for you to take a look at, as well as help articles on brake controllers and installing brake controllers that should be useful.

expert reply by: Kyle S

0

Answer 1

If your Tekonsha P3 Brake Controller, part #90195, displays the error message OUTPUT SHORTED NO BRAKES, the potential causes are a short in the brake output circuit somewhere between the brake controller and the trailer brake assemblies, or a…

view full answer...

Answer 2

The Prodigy P-3 #90195 brake controller will go into a power saving mode after 15 minutes without motion, once the vehicle ignition is turned off. The simple answer to your question is yes, but because the unit goes into power-saving mode, and…

view full answer...

Answer 3

The Prodigy P3 Brake Controller part #90195 that you referenced will control the braking power of a trailer's brakes that you are towing. Express Vans with the 7-Way tow package have the blue output brake wire already ran from the back to the…

view full answer...

Answer 4

Thank you for all of the information and pictures! It looks like you should at least have some wiring already run on your 2019 Chevy Express Van 3500 so I'm just as confused as to why you don't have a round plug with a cap inside the…

view full answer...

Answer 5

Yes, the Bolt Trailer Hitch Lock part #BL7023582 will work for you as it is a hitch lock designed for 2-1/2 inch hitches like what you have on your GMC 3500 truck. The usable portion of this lock is 3.55 inches. Check out the picture I attached for…

view full answer...

Answer 6

The Dexter 10K electric brakes #23-439 (right side) and #23-438 (left side) will have to be manually adjusted using the adjustment wheel below the magnet. To adjust the brakes you will use a small screwdriver or similar tool to turn the adjustment…

view full answer...

Answer 7

I checked directly with BOLT for you, and they confirmed for me that your 2021 Chevy Silverado is absolutely compatible with their trailer hitch locks. Take a look at the accompanying photo, and if you have the same center cut key, the correct lock…

view full answer...

Answer 8

When the 909508000 part number has come up before it has been in relation to Kwikee 40 Series Steps which use the Replacement Control Unit for Kwikee 40 Series Electric RV Steps #LC363985. Unfortunately your motorhome information doesn't actually…

view full answer...

Answer 9

We have a great option in a replacement 45 amp power converter for your ELX-45. I suggest the Progressive Dynamics, #PD4045KA. This is a 2-in-1 AC/DC distribution panel and smart charger that works with lithium-ion, flooded lead acid, AGM, and gel…

view full answer...

Answer 10

I checked with all of our wiring manufacturers and none of them have anything listed as of yet (September 2023). Since none of them have something listed for a custom-fit installation you'll need to use a universal wiring kit like the Curt…

view full answer...

Answer 11

The Chevy Vans are not actually pre-wired for a brake controller. A brake controller has to be partially hardwired in. If your 2007 Chevy Express came with a factory installed 7-Way trailer connector then the blue brake output wire should be ran from…

view full answer...

Answer 12

Some models of the 2016 Chevrolet Express Van have the brake controller connection wiring taped and tucked under the driver side floor mat up towards the firewall, which sounds like what you have especially since they are labeled as such. The brake…

view full answer...