Does Roadmaster Front Anti-Sway Bar for Trucks Item # RM-1139-180 Fit 2016 Ford F-250

Question

Question:

Will this sway bar fit 2016 f250 2wd. Thanks

asked by: Mike R

0

Expert Reply:

Yes, the Roadmaster Front Anti-Sway Bar for Trucks Item # RM-1139-180 that you referenced is a confirmed fit for your 2016 Ford F-250 2WD and would work well.

expert reply by: Jameson C

0

Answer 1

End links cannot be added for adjustability when installing the Roadmaster Rear Anti-Sway Bar #RM-1139-193 on your 2020 Ford F-350. The reason is this replaces your factory sway bar and already utilizes the factory end links, and there isn't…

view full answer...

Answer 2

Hey John, Since body lifts only move the body away from the frame and don't change the distance between the frame and suspension the lift should be irrelevant to fitment in your case. For anti-sway bars I recommend the Roadmaster Front…

view full answer...

Answer 3

There is not any drop required, nor will there be any interference with the helpers on your 2020 Ford F-350's overload springs to install the Roadmaster Rear Anti-Sway Bar #RM93VR.

view full answer...

Answer 4

Hey John, Hellwig is a bit new to our selection so I haven't gotten to get my hands on as many of their products as compared to Roadmaster. The experience I've had so far has been somewhat disappointing in terms of overall quality…

view full answer...

Answer 5

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 6

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 9

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 10

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...