Can Fulton Winch be Used With Wire Rope?

Question

Question:

Can braided cable or wire rope work on this winch. If not can you give me a list of those that do. Thank you

asked by: Larry C

1

Helpful Expert Reply:

Yes, the Fulton Single Speed Trailer Winch # F142102 can be used with 5/16" wire rope that is a maximum of 30' long. I've left a link to a video review of this product for you to take a look at.

expert reply by: Kyle S

1

Answer 1

The 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles #e69SR should be compressed ~2" under a 1,000 lb load which would make the "F" measurement ~1 3/4" with the 1,000 lb load. This is based on a formula to find…

view full answer...

Answer 2

The Fulton Single Speed Trailer Winch part #F142102 uses a standard winch mounting pattern which I have attached a photo of for you. If your winch mounting pattern does not match this then your would be best off to just re-drill as most boat trailer…

view full answer...

Answer 3

The height of the Fulton winch part #F142102 is 6 inches, the width is 5-1/4 inches without the handle and then with the handle is 10 inches. The length front to back is 7 inches.

view full answer...

Answer 4

The mounting bracket on the Fulton Single Speed Trailer Winch #F142002 is 3-5/8" wide, so it's going to be fairly close to your original bracket.

view full answer...

Answer 5

It can be a flat end as long as the flat part is long enough that it can reach past the wet bolt just fine. For your application it looks like the 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles #e69SR is the closest that we have as…

view full answer...

Answer 6

It's pretty easy to determine the correct replacement leaf springs for your trailers, and there's different ways for double-eye springs and slipper springs. You do have to account for the sag, so go with ones that measure shorter than what…

view full answer...

Answer 7

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 8

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

We do carry electric brake assemblies as well as hub/drum assemblies. To determine the correct fit, you will need to measure the spindles of your axles. I've attached a photo to assist with the measurement locations, and recommend using a digital…

view full answer...

Answer 11

We do have 205/75R14 size radial tires that have a load range of D and a speed rating of at least 81 mph. Out of our available selection I recommend going with the Kenda Karrier #AM10235. This tire has a max load rating of 2,200 lbs at 75 psi and a…

view full answer...

Answer 12

The Correct Track Trailer Alignment and Lift Kit - Tandem Axle #RR23QX does come with all of the components needed to lift a tandem axle trailer. The center hangers of a tandem axle setup use different components than the front and rear hangers since…

view full answer...

Can Fulton Winch be Used With Wire Rope?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching