Replacement Control for Kwikee Steps

Question

Question:

I have a 2005 Winnebago and was wondering if I can buy just the controller, your last answer says 1999-2005 need complete upgrade with motor and in the next paragraph it says 2005 or newer only needs controller??? Kwikee part # 909506000 Thanks

asked by: Dale B

0

Expert Reply:

You would need to know when your steps were manufactured to know if the Kwikee 9510 Control for IMGL/9510 Step Control # LC379146 would work for you, because it is designed to be used with "pre-IMGL" step units that were manufactured from 1999 to 2005. If you have the serial number you should be able to contact Lippert with that information and they can tell you when your step was manufactured.

expert reply by: Kyle S

0

Answer 1

Thank you for all of the information. Given the information you provided, the Replacement Control Unit for Kwikee Electric RV Steps #LC379146 is the correct replacement control for your steps.

view full answer...

Answer 2

I checked with Lippert and the part number you mentioned corresponds with the Revolution Kwikee step and the replacement control module you need then is the part #LC363985.

view full answer...

Answer 3

The issue you described could be either a bad door switch or a bad control module assuming you have checked all of your connections. In order to determine which of the above is causing your problem you will want to unplug the 4-pin connector for the…

view full answer...

Answer 4

The Replacement Control Unit for Kwikee Electric RV Steps #LC379146 which is part 90950600 you referenced is does not have a specific wiring diagram, but I've attached the closest thing and have also included a video of an installation to…

view full answer...

Answer 5

If the Kwikee 32 Series steps that you have were built in 2003 and you haven't done any work to them then the replacement motor that you are looking for is the part #LC379608. This is for 32 Series steps that were manufactured between 2000 -…

view full answer...

Answer 6

I went ahead and reached out to Lippert, and they confirmed that you need automatic transmission fluid Dexron III or Mercon 5 fluid. This works with their hydraulic auto leveling system. With that being said, I do not recommend using the hydraulic…

view full answer...

Answer 7

Thank you for all of the information provided. Based on that the Replacement Control Unit for Kwikee Electric RV Steps #LC379146 is the correct replacement control for your steps on your 2008 American Coach Tradition.

view full answer...

Answer 8

There's no reason why you couldn't use the #LC285344 scissor jacks to stabilize your RV when it's parked. Keep in mind these aren't meant to jack the RV off the ground, but are meant to keep the vehicle stable while you move around…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 11

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 12

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Replacement Control for Kwikee Steps

Product Page this Question was Asked From

Continue Researching