Replacement Kwikee Revolution Step Module

Question

Question:

The steps quit on my 2018 TIFFIN ALLEGRO RED . It is the control which has failed as I have installed a temporary reversing toggle and the steps work well.The module is marked inch POWERGEAR PN 1510000140 REVOB DATE CODE 17F14 inch , What module do I need ??

asked by: DENNIS C

1

Helpful Expert Reply:

I checked with Lippert and the part number you mentioned corresponds with the Revolution Kwikee step and the replacement control module you need then is the part # LC363985.

expert reply by: Jameson C

1

Answer 1

I checked with Lippert and the part number you mentioned corresponds with the Revolution Kwikee step and the replacement control module you need then is the part #LC363985.

view full answer...

Answer 2

I checked with Lippert and the part number you have of 1510000140 corresponds with the Revolution Kwikee step and the replacement control module you need then is the part #LC363985.

view full answer...

Answer 3

I checked with Lippert and the part number you have of 1510000140 corresponds with the Revolution Kwikee step and the replacement control module you need then is the part #LC363985. Based on what you described it sounds like the module is bad and…

view full answer...

Answer 4

Thank you for all of the information. Given the information you provided, the Replacement Control Unit for Kwikee Electric RV Steps #LC379146 is the correct replacement control for your steps.

view full answer...

Answer 5

You would need to know when your steps were manufactured to know if the Kwikee 9510 Control for IMGL/9510 Step Control #LC379146 would work for you, because it is designed to be used with "pre-IMGL" step units that were manufactured…

view full answer...

Answer 6

The issue you described could be either a bad door switch or a bad control module assuming you have checked all of your connections. In order to determine which of the above is causing your problem you will want to unplug the 4-pin connector for the…

view full answer...

Answer 7

It sounds like you're trying to replace the motor on your Kwikee steps with the part number 366043, and we have just what you're looking for. In order to replace the motor for these steps you'll want to use the Replacement Motor for…

view full answer...

Answer 8

The replacement module for 40 series Kwikee RV steps #LC363985 is for a new module and is the correct part for your 40 series steps that were made in 1999.

view full answer...

Answer 9

The correct replacement control for your 1510000140 step control is the Replacement Control Unit for Kwikee #LC363985. Since most of your functions seem to be working correctly, I would start by checking the 4-way connector before replacing the…

view full answer...

Answer 10

The correct replacement part for your Revolution Kwikee step P/N 1510000140, is the: -Replacement Control Unit for Kwikee 40 Series Electric RV Steps #LC363985. I have included an installation video, preformed on a 2016 Newmar Ventana LE.

view full answer...

Answer 11

Your Kwikee 1510000140 needs to be replaced with the Control Unit #LC363985. You cannot replace it with the Kwikee 9510 Controller #LC379146.

view full answer...

Answer 12

In order to test the motor on what I assume are set of Lippert Kwikee Electric Steps, you will first want to sever the yellow and red wires on the motor. Once you do this you will then need to obtain access to a 12 volt power source you know…

view full answer...

Replacement Kwikee Revolution Step Module

Product Page this Question was Asked From

Continue Researching